GE JVM2052 User Manual Page 16

  • Download
  • Add to my manuals
  • Print
  • Page
    / 24
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 15
ATTACH THE MOUNTING PLATE
TO THE WALL
B2
USE TOP CABINET TEMPLATE FOR
PREPARATION OF TOP CABINET
B3
Read the instructions on the TOP CABINET TEMPLATE.
Tape it underneath the top cabinet.
Drill the holes, following the instructions on the TOP
CABINET TEMPLATE.
CAUTION: Wear safety goggles when
drilling holes in the cabinet bottom.
Wall
Mounting
Plate
Spacing for Toggles More
Than Wall Thickness
Toggle
Bolt
Toggle Wings
To use toggle bolts:
Bolt End
You need to drill holes for the top support screws and
a hole large enough for the power cord to fit through.
Attach the plate to the wall using toggle bolts.
At least one wood screw must be used to attach
the plate to a wall stud.
Remove the toggle wings from the bolts.
Insert the bolts into the mounting plate through
the holes designated to go into drywall and reattach
the toggle wings to
3
4 onto each bolt.
1
2
Place the mounting plate against the wall and insert
the toggle wings into the holes in the wall to mount
the plate.
NOTE: Before tightening toggle bolts and wood screw,
make sure the tabs on the mounting plate touch
the bottom of the cabinet when pushed flush against
the wall and that the plate is properly centered under
the cabinet.
CAUTION: Be careful to avoid pinching
fingers between the back of the mounting plate and
the wall.
Tighten all bolts. Pull the plate away from the wall
to help tighten the bolts.
3
4
1
Remove and save 3 blower plate mounting screws
and 2 blower unit mounting screws.
ADAPT MICROWAVE OVEN
BLOWER FOR OUTSIDE BACK
EXHAUST
B4
16
Installation Instructions
Use side cutters or tin snips to cut and remove
knockouts from back plate. Discard the knockouts.
Be careful not to distort the plate.
Knockouts
Back plate
Blower unit
mounting screw
(2 screws)
Blower plate
mounting screw
(3 screws)
Blower plate
Blower unit
Page view 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Comments to this Manuals

No comments