GE JB900 User Manual download pdf (Page 27)

27

GEAppliances.com

Oven Heating Elements

Do not clean the bake element or the broil

element. Any soil will burn off when the elements

are heated.

To clean the oven floor, gently lift the

bake element. Clean with warm soapy

water.

Oven Racks

Clean the oven racks with an abrasive

cleanser or scouring pad. After cleaning,

rinse the shelves with clean water and dry

with a clean cloth.

If your oven is equipped with gray

porcelain-coated oven racks, they may

be cleaned in the oven during the self-

clean cycle.

NOTE:

■ If your oven is equipped with shiny, silver-

colored oven racks, remove them before you

begin the self-clean cycle.

■ If your oven is equipped with gray porcelain-

coated oven racks, they may be left in the oven

during the self-clean cycle.

To make the racks slide more easily, apply

a small amount of vegetable oil to a paper

towel and wipe the edges of the oven

racks with the paper towel. Do not spray

with Pam

®

or other lubricant sprays.

Broiler Pan and Grid

Do not clean the broiler pan or grid in a

self-cleaning oven.

After broiling, remove the broiler pan

from the oven. Remove the grid from the

pan. Carefully pour out the grease from

the pan into a proper container.

Wash and rinse the broiler pan and grid

in hot water with a soap-filled or plastic

scouring pad.

If food has burned on, sprinkle the grid

with detergent while hot and cover with

wet paper towels or a dishcloth. Soaking

the pan will remove burned-on foods.

Both the broiler pan and grid may be

cleaned with a commercial oven cleaner.

Both the broiler pan and grid can also

be cleaned in a dishwasher.

After broiling, remove the broiler pan

from the oven. Do not store a soiled

broiler pan and grid anywhere in

the range.

Oven Light Replacement

CAUTION: Before replacing your oven light

bulb, disconnect the electrical power to

the range at the main fuse or circuit breaker

panel.

Be sure to let the light cover and bulb

cool completely.

To remove the cover:

Hold a hand under the cover so it

doesn’t fall when released. With

fingers of the same hand, firmly

push back the wire cover holder.

Lift off the cover.

Do not remove any screws to remove the cover.

Replace bulb with a 40-watt

appliance bulb.

To replace the cover:

Place it into groove of the light

receptacle. Pull wire forward to the

center of the cover until it snaps

into place.

Connect electrical power to the

range.

Wire cover holder.

Safety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer Support

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 39 40

Comments to this Manuals

No comments