GE PSB48YPHSV Instruction Manual download pdf (Page 34)

100

4A ALTERNATE ANTI-TIP

PRECAUTIONS

SKIP THIS STEP WHEN USING ANTI-TIP BRACKETS

All GE Profile

™

built-in refrigerators are Top-Heavy.

They must be secured to prevent the possibility

of tipping forward. Use this alternative method to

secure the refrigerator whenever steel wall studs

are encountered.

• Adjust height of refrigerator to match

installation cutout opening 83-1/2” to 84-1/2”.

The refrigerator must be level and plumb with

cabinets. The top case trim at the front is 2-1/8”

higher than the rear and will overlap upper

cabinets or cabinet trim.

• Open grille panel to access the top case trim.

• Use a 3/16” bit to drill 4 evenly spaced clearance

holes through the metal top case trim.

• Use a 1/16” bit to drill pilot holes through the

metal clearance holes and into wood soffit. The

holes should be centered in the soffit or a 3/4”

minimum wood brace. The brace spanning the

enclosure must be securely fastened to cabinets

on both sides.

• Install four 1-1/2” drywall screws into the pilot

holes.

2A WATER LINE INSTALLATION WITH

A REVERSE OSMOSIS SYSTEM

SKIP THIS STEP WHEN NOT USING AN RO SYSTEM

NOTE: If the water supply to the refrigerator

is from a Reverse Osmosis Water System, use

the refrigerator’s filter bypass plug. Using the

refrigerator’s water filtration cartridge with

the RO filter can result in hollow ice cubes.

• Open the top grille to view the filtration cartridge.

Rotate the filtration cartridge counterclockwise

until removed.

• Insert filter bypass plug. Rotate the filter bypass

plug clockwise until tightly secured in place.

INSTALL ANTI-TIP BRACKETS

WARNING:

The refrigerator is Top-Heavy and must be secured

to prevent the possibility of tipping forward.

•

Cut a 2” x 4” wood block 36” long,

and secure the block

to the mounting

brackets

provided, using

#12 or #14

wood screws.

•

Secure the brackets

with wood block

to the back wall so

that it is 82” (or the rear

installation height) from the finished floor. Use #12

or #14 wood screws.

•

Screws must penetrate at least 1” into vertical

wall studs.

3 INSTALL SIDE PANELS

SKIP THIS STEP WHEN NOT USING SIDE PANELS

If you are using 1/4” side panels, they should be

inserted into the case trim. Fasten the panels to the

refrigerator with the 3M Dual Lock adhesive strips

before setting refrigerator in place.

Install (4) 1-1/2” Drywall Screws

Through Trim and Into Soffit

or 3/4” Min. Wood Brace

Top Case Trim

Side View

Top Case Trim

(3/4 “)

min.

ANTI-TIP

PRECAUTIONS

Positioned

Anti-Tip

Bracket

Wall Stud

(Behind

Drywall)

Wood Screws

Mounted into

Vertical

Wood Studs

36"

Installation Instructions

Master Power Switch

Water Filter

Rotate Counterclockwise To Remove

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 99 100

Comments to this Manuals

No comments

GE PSB48YPHSV Instruction Manual Page 34

Comments to this Manuals

Related products and manuals for Fridges GE PSB48YPHSV