GE PSB48YPHSV Instruction Manual download pdf (Page 10)

10

Ice Storage Bin

To remove:

Lift up the access door to reach the

icemaker. Set the icemaker power switch

to the O (off) position. With the access door

closed, support the storage bin at

the bottom while slightly lifting. Pull bin

straight out.

To replace:

Slide the bin back until the tab on

the bin locks into the slot on the shelf.

If the bin does not go all the way back,

remove it and rotate the drive mechanism 1/4

turn. Then push the bin back again.

Important facts about your

ice and water dispenser

 Do not add ice from trays or bags to the

storage bin. It may not crush or dispense well.

 Avoid overfilling glass with ice and use of

narrow or extra-tall glasses. Backed-up ice

can jam the chute or cause the door in the

chute to freeze shut. If ice is blocking the

chute, poke it through with a wooden spoon.

 Beverages and foods should not be

quick-chilled in the ice storage bin.

Cans, bottles or food packages in the storage

bin may cause the icemaker

or auger to jam.

 To keep dispensed ice from missing

the glass, put the glass close to, but not

touching, the dispenser opening.

 Some crushed ice may be dispensed

even though you selected CUBED. This

happens occasionally when a few cubes

accidentally get directed to the crusher.

 After crushed ice is dispensed, some water

may drip from the chute.

 The first glass of water dispensed may

be warmer than the following ones.

This is normal.

About the ice and water dispenser and automatic icemaker.

A newly installed refrigerator may take 12 to 24 hours to begin making ice.

Automatic Icemaker

A newly-installed refrigerator may take 12–24

hours to begin making ice.

The icemaker will produce seven cubes per

F\FOH³DSSUR[LPDWHO\F\FOHVRUPRUHLQ

a 24-hour period, depending on freezer

compartment temperature, room temperature,

number of door openings

and other use conditions.

If the refrigerator is operated before

the water connection is made to the icemaker,

set the power switch to O (off).

When the refrigerator has been connected

to the water supply, set the power switch

to I (on). The green light will come on.

Throw away the first full bucket of ice.

Be sure nothing interferes with the sweep

of the feeler arm.

When the bin fills to the level of the feeler arm,

the icemaker will stop producing ice.

It is normal for several cubes to be joined

together.

If ice is not used frequently, old ice cubes will

become cloudy, taste stale and shrink.

After the icemaker has been turned on again,

there will be a delay of about 45 minutes before

the icemaker resumes operations.

NOTE: In homes with lower-than-average water

pressure, you may hear the icemaker water

valve cycle on several times when making one

batch of ice. Recommended water pressure is

60 psi.

Feeler Arm

Ice maker

Green Power

Light

Power

Switch

Ice Storage

Bin

Access Door

Rotate

Drive

Mechanism

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 99 100

Comments to this Manuals

No comments