GE SPMM & SYMM Installation Guide download pdf (Page 2)

MOUNTING FINAL ASSEMBLY

PHOTOELECTRIC CONTROL

The photoelectric control receptacle (if present) should

be oriented before the control is installed. Loosen the two

screws and rotate the receptacle until “NORTH” is directed

to true North. Retighten screws and install control.

MAINTENANCE AND CLEANING

CAUTION

Risk of burn

• Allow lamp/fixture to cool before

handling

It will occasionally be necessary to clean the outside

of the refractor to maintain the light level. Frequency of

cleaning will depend on the ambient dirt level and the

minimum light level which is acceptable to the user. The

lens door should be washed in a solution of warm water and

any mild, non-abrasive household detergent, rinsed with

clean water and wiped dry. Should the optical assembly

become dirty on the inside, wipe the reflector and clean the

lens door in the above manner, and replace any damaged

gasket.

LAMP INSTALLATION/REPLACEMENT

The light output of a luminaire is also dependent on the

age of the lamp. In applications where the light level is

critical it may be desirable to replace lamps before they

reach end of life. The lamp manufacturer can provide data

showing how the lamp light output decreases with use.

Use only lamps specified on nameplate. Observe

lamp manufacturer’s recommendations and restric-

tions on lamp operation, particularly ballast type,

burning position, etc.

The lamp should be tightened to a light firmness

sufficient to depress the center socket contact.

SYM Mounting: Figure 3

1. Insert the pigtail leads into one leg of the yoke mount as

you assemble the yoke mount to the luminaire. Tighten

the two screws at each coupling to secure the luminaire.

2. Remove the wiring access cover and mount the lumi-

naire on the pole. Secure and level the luminaire by

adjusting the four setscrews on the hub.

3. Follow the appropriate guide lines in the WIRING

section of these instructions. Replace the wiring access

cover.

Figure 2

Cover Screw

Figure 3

CAUTION

Unit will fall if not installed properly

• Follow installation instructions

SPM Mounting: Figure 2

1. Attach the mounting bracket and nut plate to pole

with 2 of the 3/8-inch #16 bolts furnished.

2. Attach the luminaire to the mounting bracket with two

3/8-inch #16 hex head bolts. Insert the luminaire power

leads into the pole.

3. Install the decorative cover from the top and secure with

the enclosed screw.

4. Connect the proper luminaire leads to the supply leads

in the pole. Refer to the instructions in the WIRING

section.

1 2 3 4

Comments to this Manuals

No comments

GE SPMM & SYMM Installation Guide Page 2

Comments to this Manuals

Oregon Scientific Strumenti di misura manuali utente

GE SPMM & SYMM Installation Guide Page 2

Comments to this Manuals

Related products and manuals for Floodlights GE SPMM & SYMM

Oregon Scientific Strumenti di misura manuali utente