GE SPMM & SYMM Installation Guide download pdf

GEH-5833

INSTRUCTIONS

Decashield

175 Luminaire

READ THOROUGHLY BEFORE INSTALLING

GENERAL

This luminaire is designed for outdoor lighting applica-

tions, and should not be used in areas of limited ventila-

tion, or in high ambient temperature enclosures; it should

be installed and maintained according to following recom-

mendations.

UNPACKING

This luminaire has been properly packed so that no parts

should have been damaged during transit. Inspect to

confirm.

INSTALLATION

WIRING:

Make all electrical connections in accordance with

the National Electrical Code and any applicable

local code requirements.

Verify that supply voltage is correct by comparing it

to nameplate.

If unit is designated as multivolt or multiwatt,

follow specific instruction.

Do not remove insulated connectors from wires not

needed for required voltage connection.

Pigtail leads are provided for supply connection. System

neutral should be connected to the white lead. Green lead

is equipment ground.

SINGLE VOLTAGE UNITS: Are completely wired so

that the user needs to connect only the supply conductors

to the primary leads and the fixture ground.

MULTIVOLT UNITS:

a) Internally Reconnectable Multi-Volts: If no line voltage is

specified on the nameplate, or if a voltage other than the

one specified is required, refer to Figure 1 and open the

luminaire and gain access to the ballast. Make the

desired voltage selection as outlined in the instruction

tag attached to the black lead with the insulated

terminal. Be careful to move only the one lead having

the insulated terminal; then proceed with the installa-

tion.

b) Externally Reconnectable Multi-Volts: (120 or 277

volts) Follow the connection diagram on the wiring

label attached to the luminaire for proper wiring.

Figure 1

WARNING

Risk of electric shock

• Turn power off before servicing

– see instructions

These instructions do not purport to cover all details or variations in equipment nor to provide for every possible contingency to be met in connection with installation, operation or

maintenance. Should further information be desired or should particular problems arise which are not covered sufficiently for the purchaser’s purposes, the matter should be referred

to GE Lighting Solutions.

Lighting Solutions

1 2 3 4

Summary of Contents

Page 1 - 175 Luminaire

GEH-5833INSTRUCTIONSDecashield® 175 LuminaireREAD THOROUGHLY BEFORE INSTALLINGGENERALThis luminaire is designed for outdoor lighting applica-tions, an

Page 2 - LAMP INSTALLATION/REPLACEMENT

MOUNTING FINAL ASSEMBLYPHOTOELECTRIC CONTROLThe photoelectric control receptacle (if present) shouldbe oriented before the control is installed. Loose

Page 3 - Luminaire Decashield

GEH-5833INSTRUCTIONSLuminaire Decashield ® 175À LIRE TOTALEMENT AVANT D'INSTALLERPRÉSENTATIONCe luminaire est conçu pour fournir un éclairage à l

Page 4 - ATTENTION

MONTAGE35-201578-7K(12/00)ASSEMBLAGE FINALCOMMANDE PHOTOÉLECTRIQUELe réceptacle de la commande photoélectrique (si elle est installée)doit être orient

Comments to this Manuals

No comments

GE SPMM & SYMM Installation Guide

Browse online or download Installation Guide for Floodlights GE SPMM & SYMM. GE SPMM & SYMM Installation Guide User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Floodlights GE SPMM & SYMM