Ge Monogram ZMC1090BV User Manual download pdf (Page 13)

Determine

need for

filler panels

Filler panel

construction

If the cabinets being used have an opening that is

taller than the maximum dimensions indicated for

the ovens, filler panels can be made to fill the gaps.

Stock filler strips are usually available or for larger

gaps order an extra drawer front. Drawer fronts are

recommended because they will match the cabinetry

and have finished edges. Any cut edges will be seen

and should be finished.

Frameless cabinets usually come with a front panel

covering the opening. For the optimum finished look,

this panel can be removed and used to construct filler

panels.

The oven support floor and supports should be

installed at the required locations.

If there is a gap between the oven support floor and

the bottom of the opening, a bottom filler panel

should be constructed to fill the gap.

Measure from the oven support floor to the top of the

opening. If the opening height is larger than the

maximum cutout height, a filler panel should be

constructed to fill the gap.

We suggest that the filler panel be constructed using

4 pieces:

• Appearance panel to match doors and drawers.

• A rail which will be covered by the oven overlaps

and conceal any slight gap between the top or

bottom of the oven and the start of the filler panel.

The face of the rail should be made of finished

matching material; the cut edges and ends do not

need to be finished.

• Cleats which will be used to secure the filler panel

and rail to the cabinet. One for each side.

Cabinetry Modifications Suggestions

Built-In Ovens

1 ... 12 13 14 15 16 17 18 19 20

No comments

Ge Monogram ZMC1090BV User Manual Page 13