Ge JK91527 User Manual download pdf (Page 24)

24

Safety Instructions

Operating Instructions

Care and CleaningTroubleshooting TipsConsumer Support

Care and cleaning of the oven.

Press down and pull out.

Removable Oven Floor

To remove the oven floor:

Remove the oven door using the

instructions in the Lift-Off Oven Door

section of this manual.

Press down and pull out the

removable oven floor.

Clean the oven floor with warm

soapy water.

When re-installing the oven floor, be

sure to slide it all the way to the back

of the oven.

IMPORTANT: Always replace the

removable floor before the next use.

The gasket is designed with a gap at the

bottom to allow for proper air circulation.

Do not rub or clean the door gasket—

it has an extremely low resistance to

abrasion.

If you notice the gasket becoming worn,

frayed or damaged in any way or if it has

become displaced on the door, you should

have it replaced.

To clean the inside of the door:

■ Because the area inside the gasket is

cleaned during the self-clean cycle, you

do not need to clean this by hand.

■ The area outside the gasket and

the door liner can be cleaned with a

soap-filled steel-wool or plastic pad,

hot water and detergent. Rinse well

with a vinegar and water solution.

To clean the outside of the door:

■ Use soap and water to thoroughly

clean the top, sides and front of the

oven door. Rinse well. You may also

use a glass cleaner to clean the glass

on the outside of the door. Do not let

water drip into the vent openings.

■ If any stain on the door vent trim is

persistent, use a soft abrasive cleaner

and a sponge-scrubber for best results.

■ Spillage of marinades, fruit juices,

tomato sauces and basting materials

containing acids may cause

discoloration and should be wiped

up immediately. When surface is cool,

clean and rinse.

■ Do not use oven cleaners, cleaning

powders or harsh abrasives on the

outside of the door.

Cleaning the Oven Door

The door is very heavy. Be careful when

removing and lifting the door.

Do not lift the door by the handle.

To remove the door:

Fully open the door.

Pull the hinge locks down toward

the door frame, to the unlocked

position. A tool, such as a small

flat-blade screwdriver, may be

required.

Firmly grasp both sides of the door

at the top.

Close door to the door removal

position, which is halfway between

the broil stop position and fully

closed.

Lift door up and out until the hinge

arm is clear of the slot.

To replace the door:

Firmly grasp both sides of the door

at the top.

With the

door at the

same angle as

the removal

position, seat the

indentation of

the hinge arm

into the bottom

edge of the hinge

slot. The notch in the hinge arm

must be fully seated into the bottom

of the slot.

Fully open the door. If the door will

not fully open, the indentation is

not seated correctly in the bottom

edge of the slot.

Push the hinge locks up against the

front frame of the oven cavity, to the

locked position.

Close the oven door.

Hinge lock

Lift-Off Oven Door

Removal position

Indentation

Bottom

edge

of slot

Hinge lock

Slot

Push hinge locks up to lock

Pull hinge locks down to unlock

Hinge arm

Hinge

arm

1 ... 23 24 25 26 27 28 29 30 31 32

Comments to this Manuals

No comments