Ge Monogram ZVC36 User Manual download pdf (Page 21)

Installation Instructions

STEP 5 INSTALL BLOWER MOTOR

1. Pick up blower motor and rotate so tabs align

with damper plate bracket.

2. Insert blower motor into insert sleeve through

cutout opening of custom cabinet frame.

3. Place blower motor on damper plate assembly

by sliding blower motor tabs into slots of damper

plate assembly.

4. While holding blower motor in place, lift right side

so that blower motor bolt holes align with bolts

protruding from damper plate assembly and

secure with lock washers and wing nuts (hand

tighten).

STEP 6

CONNECT WIRING HARNESS

NOTE: Connect three routing clips annd two wiring harnesses on double blower models.

1. Locate both ends of wiring harness.

2. Connect wiring harness by inserting male into

female opening.

3. Carefully route wiring harness and ground wire

through two clips attached to blower plate

assembly.

Wiring

harness

Brackets

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 67 68

No comments

Ge Monogram ZVC36 User Manual Page 21