GE JT5000DFWW Use and Care Manual download pdf (Page 13)

CARE AND CLEANING

Maintenance

SHOCK OR BURN HAZARD: Before replacing oven light bulb, disconnect the electrical

power to the oven at the main fuse or circuit breaker panel. Failure to do so may result in

electric shock or burn.

WARNING

BURN HAZARD: The glass cover and bulb should be removed when cool. Touching hot

glass with bare hands or a damp cloth can cause burns.

CAUTION

Oven Light Replacement

1. Disconnect power at the main fuse or circuit breaker

panel.

2. Remove oven racks.

3. Slide a flat blade screwdriver between the housing

and the glass light cover.

4. Support the glass light cover with two fingers to

prevent the cover from falling to the bottom of the

oven.

5. Gently twist the screwdriver blade to loosen the glass

light cover. Be careful not to chip the oven coating.

6. Remove the glass light cover.

7. Remove the bulb by firmly grasping and sliding the

bulb straight out until the two prongs have cleared the

ceramic holder.

8. Do not touch the glass of the new replacement bulb

with your fingers. It will cause the bulb to fail when it

lights. Grasp the replacement bulb with a clean towel

or facial tissue with the prongs facing down. Align the

two prongs in the ceramic holder, pressing gently until

the bulb is securely in the ceramic socket.

9. Slide the protective lens into the holder and push until

the clips snap into the housing.

10. Reconnect power.

Do not lift the door by the handle.

To remove the door:

1. Fully open the door.

2. Pull the hinge locks down toward the door frame, to

the unlocked position. A tool, such as a small flat-

blade screwdriver, may be required.

3. Firmly grasp both sides of the door at the top.

4. Close door to the door removal position. The door

should be open approximately 3" with no obstruction

above the door.

5. Lift door up and out until both hinge arms are clear of

the slots.

To replace the door:

1. Firmly grasp both sides of the door at the top.

2. Starting on the left side, with the door at the same

angle as the removal position, seat the indentation of

the hinge arm into the bottom edge of the hinge slot.

The notch in the hinge arm must be fully seated into

the bottom of the slot. Repeat for right side.

3. Fully open the door. If the door will not fully open, the

indentation is not seated correctly in the bottom edge

of the slot.

4. Push the hinge locks up against the front frame of the

oven cavity, to the locked position.

5. Close the oven door.

Lift-Off Oven Door

The door is very heavy. Be careful when removing and lifting the door.

Removal position

Hinge lock

Slot

Pull hinge locks down to unlock

Push hinge locks up to lock

Hinge

lock

Hinge

arm

Indentation

Bottom

edge of

slot

Hinge arm

1 ... 12 13 14 15 16

Comments to this Manuals

No comments

GE JT5000DFWW Use and Care Manual Page 13

Comments to this Manuals

Related products and manuals for Cookers GE JT5000DFWW