GE JVE40DTBB Owner's Manual download pdf (Page 13)

49-80622-5

TROUBLESHOOTING CHECKLIST

If the hood seems to be operating at high speed when

the control is not set on high, or if ventilation seems

LQDGHTXDWHFKHFNWKHIROORZLQJ

 Knockouts not removed from hood.

 Damper blade not opening.

 Reduced airflow because the duct is too small or the

duct length is too long.

 The duct is blocked.

 Undersized or restrictive wall or roof cap.

REPLACE WIRING COVER

Replace the wiring cover.

CONNECT WIRING

Connect house black to hood black wire, house white

to hood white wire, and house ground to hood green/

yellow wire. Securely tighten the strain relief clamp

onto the house wiring.

CONNECT DUCTWORK TO HOOD

Use duct tape to make joints secure and air tight.

Note: Illustration shows rectangular to round duct adapter.

Duct tape

REPLACE FILTERS

The installation is complete. Turn on power at service

panel, and test for proper operation.

Installation Instructions

WARNING:

- Lamp contains Mercury. Manage in accord with

disposal laws. See www.lamprecycle.org or 1-800-435-4448.

For installation, handling and disposal precautions, refer to

the fluorescent lamp packaging literature.

WARNING:



To reduce the risk of electric shock, do not connect electrical

power to the hood without both lamps in place.

CAUTION:

 Do not touch the hood lamps when they are on. They may

be hot enough to cause injury.

 To prevent injury from broken lamps, handle lamps carefully

and do not operate hood without lamp lens covers in place.

This hood requires two Compact Fluorescent Lamps (CFL)

with a GU24 base (included), maximum 15 watts.

To change the lamps:

When installing or replacing a lamp, make sure that

power to the light has been turned off. Never allow a

lamp to come into contact with water.

Remove the lens cover by sliding it in a horizontal direction

and pulling it down and away from the hood.

Grasp the lamp by the plastic base portion of the lamp

and unscrew it.

Replace with energy saving GE 15W Compact Fluorescent

/DPSZLWK*8EDVH*(6HUYLFH3DUW:%;

INSTALL LAMPS

FOLLOW ELECTRICAL CODE

Complete the electrical wiring according to National

Electrical Code and local codes.

NOTE: This hood must be permanently grounded.

Connect house wiring (120 VAC) to hood wiring.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 31 32

Comments to this Manuals

No comments

GE JVE40DTBB Owner's Manual Page 13

Comments to this Manuals

Related products and manuals for Cooker hoods GE JVE40DTBB