GE P54S Installation Guide download pdf

GEH-5751B

INSTRUCTIONS

P-154 Powerflood

Floodlight

READ THOROUGHLY BEFORE INSTALLING

AVERTISSEMENT; COUPER L’ALIMENTATION

AVANT L’INSTALLATION OU L’ENTRETIEN.

GENERAL

This luminaire is designed for outdoor lighting service,

and should not be used in areas of limited ventilation, or in

high ambient temperature enclosures. Best results will be

obtained if installed and maintained according to the

following recommendations.

UNPACKING

This luminaire has been properly packed so that no part

should have been damaged during transit. Inspect to

confirm.

INSTALLATION

WIRING

Make all electrical connections in accordance with

the National Electrical Code and any applicable

local code requirements.

Verify that supply voltage is correct by comparing it

to nameplate.

If unit is designated as multivolt or multiwatt,

follow specific instruction.

Three-conductor No. 14 cable (with 90°C minimum

insulation) is recommended for making electrical

connections to the P-154. After opening door loosen the 2

screws holding the reflector. Remove reflector thus expos-

ing the terminal board. Loosen screw in pressure plate,

insert cable through grommet and retighten screw. (Notice

that grommet fits cable of approximately 9/16-inch

diameter.) Grommet and pressure plate form a weather

proof seal and strain relief. To maintain this seal, the screw

in pressure plate must be retightened whenever the seal is

disturbed. After connections are made to the terminal

board, be sure insulating shield is properly placed.

CAUTION

Unit will fall if not installed properly

• Follow installation instructions

WARNING

Risk of electric shock

• Turn power off before servicing

– see instructions

The floodlight is provided with a trunnion bracket which

can be mounted directly on flat surfaces, or building fronts.

Mounting adaptors are available for installation on poles,

cross-arms, pipes, etc. The trunnion bracket has a clearance

hole for a 3/4-inch bolt used for attachment of such

mounting. The 1/2-inch holes on either side of the

3/4-inch hole permit additional anchoring, if required.

Tighten side trunnion bolts to 18 - 22 foot pounds.

AIMING

Slightly loosen bolts “A” (two on trunnion), tilt

luminaire to desired position and retighten bolts.

These instructions do not purport to cover all details or variations in equipment nor to provide for every possible contingency to be met in connection with installation, operation or

maintenance. Should further information be desired or should particular problems arise which are not covered sufficiently for the purchaser’s purposes, the matter should be referred

to GE Lighting Solutions.

Lighting Solutions

1 2

Summary of Contents

Page 1 - Floodlight

GEH-5751BINSTRUCTIONSP-154 Powerflood® FloodlightREAD THOROUGHLY BEFORE INSTALLINGAVERTISSEMENT; COUPER L’ALIMENTATIONAVANT L’INSTALLATION OU L’ENTRE

Page 2 - MAINTENANCE

35-201578-T5 (1/00)Connect ground lead to the green lead, greenground screw on housing or terminal blockprovided.Do not remove insulated connectors fr