GE GFT14ESSLWW Manual and User Guide Page 20

  • Download
  • Add to my manuals
  • Print
  • Page
    / 80
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 19
20 49-90571 -1
Installation Instructions
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT Save these instructions for
local electrical inspector’s use.
IMPORTANT Observe all governing
codes and ordinances.
Note to Installer Be sure to leave these
instructions with the Consumer.
Note to Consumer Keep these instructions for
future reference.
• Service must be performed by a qualified installer.
Do not allow children on or in the appliance. Close
supervision of children is necessary when the
appliance is used near children.
Proper installation is the responsibility of the installer.
REQUIREMENTS FOR ALCOVE OR
CLOSET INSTALLATION
Keep flammable materials and vapors, such as gasoline,
away from dryer.
Place dryer at least 18” (46 cm) above the floor for a
garage installation.
Failure to do so can result in death, explosion, or fire.
Minimum clearance between dryer cabinet and
adjacent walls or other surfaces is:
1” either side
3” front and rear
1” top
Consideration must be given to provide adequate
clearance for installation and service.
Closet doors must be louvered or otherwise
ventilated and have at least 60 square inches of
open area. If the closet contains both a washer
and a dryer, doors must contain a minimum of 120
square inches of open area.
MINIMUM CLEARANCE OTHER
THAN ALCOVE OR CLOSET
INSTALLATION
Minimum clearance to combustible surfaces and
for air opening are: 1” both sides, 3” rear and 1” top.
Consideration must be given to provide adequate
clearance for installation and service.
- Explosion Hazard
WARNING
GE APPLIANCES STACK KIT
Order on-line at GEApplianceParts.com, 24 hours
a day or by phone at 877.959.8688 during normal
business hours.
Part Number Accessory
GFA24KITL Complete Stack Kit
STACKING THE WASHER AND DRYER (if desired)
If you are planning to stack the washer and dryer, order Stacking Kit number GFA24KITL to be used for this dryer.
Kit sold separately.
INSTALLATION PREPARATION
Remove the packaging.
Flatten the product carton to use as a pad to lay the
dryer down on its side. Continue using the carton to
protect the finished floor in front of the installation
location.
TOOLS YOU WILL NEED
Level
Phillips
screwdriver
Gloves
KIT CONTENTS (GE APPLIANCES
KIT # GFA24KITL)
Screws (2) Long
For dryer
attachment
Bracket-
stack (R)
Bracket-
stack (L)
Screws (6) Short
For washer attachment
Page view 19
1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 79 80

Comments to this Manuals

No comments