GE MDS 05-4558A01 User Manual download pdf (Page 9)

8 MDS Mercury Series Startup Guide 05-4558A01, Rev. C

Scanning

—The unit is looking for an Access Point beacon signal.

Ranging

—Unit is adjusting power, timing, and frequency with an AP.

Connecting

—Unit has an RF connection with the AP.

Authenticating

—(When Device Authentication is in use) The Remote

is authenticating itself to the network to obtain security clearance.

Associated

—The unit has successfully synchronized and associated

with an Access Point. This is the normal status.

Alarmed—The unit is has detected one or more alarms that have not

been cleared.

c. When the network is operating properly based on observation

of the unit’s LEDs, connect a computer to the transceiver’s

data port that will be used by the local terminal equipment.

Send the

PING command to verify communications link integ-

rity with the Access Point.

d. After the

PING is successful, connect the terminal equipment

to the radio’s data port and verify normal operation.

If all checks are OK, you are finished with the installation at this site.

Resetting to Factory Defaults (Use with Caution)

Selecting Maintenance/Tools>Reset to Factory Defaults sets all trans-

ceiver parameters back to their factory defaults. This may be useful

when several parameters have been modified and there is no track of

changes. It causes the transceiver to return to a known factory state.

Use this function with care, as all user-customized settings will be

cleared.

AIMING DIRECTIONAL ANTENNAS

Directional antennas usually require some fine-tuning of their bearing

to optimize the received signal strength. The unit has a built-in

received signal strength indicator (RSSI) that can be used to optimize

the received signal level. It is available under the

Performance Informa-

tion

menu.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

No comments

GE MDS 05-4558A01 User Manual Page 9