TO DC POWER SUPPLY
(10–30 Vdc)
RTU/PLC
(Crossover Cable
to Radio)
LOW-LOSS FEEDLINE
(To 900 MHz Antenna)
INST
INST
ALLA
ALLA
TION REFERENCE CHART
TION REFERENCE CHART
ANTENNA
SYSTEM
PC RUNNING
TERMINAL
PROGRAM
(Straight-Through
Cable to Radio)
TO GPS ANTENNA
(Provides 3.3 Vdc output)
Step 1 – Mount the Transceiver
Step 2 – Install the Antennas
Step 3 – Measure & Connect Primary Power
(10–30 Vdc)
Step 4 – Review the Transceiver’s Configuration
Network Name—Unique name for each radio network. Required for
Remotes to associate with the Access Point. (Default name is
MDS-Mercury.)
IP Address—Must be a unique number to allow for IP access
through the Ethernet Port.
NOTE: A unique IP address is essential to access the web browser-based
Management System.
RF Output Power—Adjust as necessary for regulatory compliance.
Username/Password—Used for remote access and some Management
System features. (Username and Password default = admin)
Step 5 – Connect the Data Equipment
Connect the data equipment to data port(s):
• LAN—10/100BaseT Ethernet-compatible equipment:
Ethernet PLC (Crossover cable); Ethernet switch (Straight-Through)
• COM1—RS/EIA-232 compatible equipment (Crossover cable to serial
PLC/RTU)
tep 6 – Check for Normal Operation
Observe the transceiver LED status panel for the proper indications. In a normally operating system, the following LED indications s
hould be seen within 30 seconds of power-up:
WR—Lights continuouslyL AN—On or blinks intermittently LINK— On or blinks intermittently (Remotes: if associated)
U se PING command to test basic data link integrity between Access Point and Remotes.
I f the PING command is successful, connect the RTU/data equipment to the data port and verify normal operation.
I f the LINK LED on Remotes is not on after 2 or 3 minutes, the unit has failed to associate with the Access Point. It may be necessary t
o reposition or redirect the radio’s antenna for better reception/signal strength. Check also GPS antenna system.
C heck connected data equipment for normal operation.
Detailed instructions are contained in the Reference Manual, P/N 05-4446A01
INSTALLATION SUMMARY
BASIC CONFIGURATION DEFAULTS
TYPICAL INSTALLATION—Remote Shown
The Management System can be accessed through the COM1 Port using a terminal emulator. The basic items listed below, and
many other parameters and tools can be accessed through this tool. HTTP, Telnet access, and changing parameters are controlled
by password.
VALUES/RANGE
•1–8 alphanumeric characters
•Case-sensitive; can be mixed case
• 1–16 alphanumeric characters
• Case-sensitive; can be mixed case
Contact your Network Administrator
AP: -30 to +30 dBm RM: 0 to +30 dBm
DEFAULT
admin (lower case)
ITEM MGT SYSTEM MENU
Username/Password Device Information
Network Name Network Configuration
IP Address Network Configuration
RF Output Power Radio Configuration
MDS-Mercury
192.168.1.1
+30 dBm (900 model)
+20 dBm (3650 model)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals