GE General Electric Heat Pump 5100 User Manual download pdf (Page 20)

Zoneline

Doesn’t Start

Zoneline Does Not

Cool or Heat as it

Should

The unit is unplugged • Make sure the Zoneline plug is

pushed completely into the outlet.

The fuse is blown/circuit • Check the house fuse/circuit breaker

breaker is tripped box and replace fuse or reset the

breaker.

The unit is waiting for the • This is normal. The Zoneline will start

compressor overload again after it resets.

protector to reset

Problem Possible Causes What to Do

Airflow is restricted • Make sure there are no curtains, blinds

or furniture blocking the front of the

Zoneline.

The temp control may • Turn the control to a lower or higher

not be set high or low number.

NOTE: The temperature limiter may

enough

be limiting the temperature range.

The air filter is dirty • Clean the filter at least every 30 days.

The room may have been • When the Zoneline is first turned on

hot or cold you need to allow time for the room to

cool down or warm up.

Air is escaping • Set the vent control in the

position.

If Something Goes Wrong

Before you call for service

1 2 ... 15 16 17 18 19 20 21 22 23 24

No comments

GE General Electric Heat Pump 5100 User Manual Page 20