Ge ZIDI240BII User Manual Page 4

  • Download
  • Add to my manuals
  • Print
  • Page
    / 8
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 3
Design Guide
4
THE INSTALLATION SPACE
I
MPORTANT: Double-Drawer Refrigerators are
designed to be built-in only. They cannot be used
free-standing.
NOTE: The unit is designed to be flush with the
surrounding cabinets.
Additional Specifications
A 120 volt 60Hz., 15 or 20 amp power supply is required.
An individual properly grounded branch circuit or circuit
breaker is recommended. Install a properly grounded
3-prong electrical receptacle recessed into the back
wall as shown. Electrical must be located on rear wall
as shown. NOTE: GFCI (ground fault circuit interrupter)
is not recommended.
PRODUCT CLEARANCES
W
hen installed
in a corner:
Allow 2-1⁄2" min. clearance between Double-Drawer
and adjacent cabinet, wall or other appliances.
Allow 22" min. clearance from the front for drawer
opening.
NOTE: Clearances are based on the noted 2-1⁄8" handle
standoff depth.
Test the drawer openings. Carefully open and close
the drawers. The drawers should not rub or catch on
adjacent cabinetry. Notify the installer if the drawers
make contact with cabinetry.
Choose the location:
These products may be closed in on the top and
three sides as long as the front is unobstructed for
air circulation and proper access to the drawers.
Do not install these products where the temperature
will go below 55°F (13°C) or above 90°F (32°C).
These products are not designed to be stacked one over
the other.
SIDE-BY-SIDE INSTALLATIONS
Stainless Steel Models Only
For a complete refreshment center, install a Double-Drawer
Refrigerator beside a Beverage Center, Wine Chiller/
Wine Reserve, Fresh-Food Refrigerator or Bar Refrigerator
with Icemaker.
A side-by-side installation requires at least a 47-1/2" wide
opening. No trim kits required.
Products must operate from separate, properly grounded
receptacles.
34-1/2"-35"
24"
47-1/2" Min.
1-1/2"
9"
10-1/2"
9"
10-1/2"
14"
15"
Locate
Outlet
Allow 22" clearance
at the front for full
extension of drawers.
FOR MODEL ZIDS240 WITH STAINLESS STEEL DRAWERS AND HANDLES
Clearance for Door
Opening 2-1/2" min.
C
ountertop
Double-Drawer
22" min.
Page view 3
1 2 3 4 5 6 7 8

Comments to this Manuals

No comments