Ge 49-8255 User Manual download pdf (Page 28)

INSTALLATION INSTRUCTIONS

(continued)

РЮШ» Ш тят («entd)

Your range, like many other household

heavy and can зеШе into soft

u,-Ante «С

floor coveri^s such as cushioned vinyl or

cai^eting. When moving the range on this type^

of flooring, use care, and foiiow these simple and

inexpensive instructions.

The range should be installed on a 1/4 mch thick

sheet of plywood (or similar material) as follows:

When the floor eovering ends at the front of the

rangOf die area that the range will rest on should

be built up with plywood to the same level or

higher than the floor covering. Шз will aUow

the range to be moved for cleaning or servicing.

WlRiNG UUVbH

(SHOWN REMOVED)

STRAIN RELIEF BRACKETS

(PROVIDED WITH RANGE CORD ,

SET. NOT PART OF RANG^ \M

CONNECTOR

BLOCK

POWER

CORD

SfiP2 , .

Pii^i ¥m c®iigc?i®i

Use only a 3-conductor, or if required a 4-

conductor range cord set as noted below, 'píese

cord sets are provided with ring type terminals.

'The electrical rating of the cord must be 125/250

volts minimum, 40 amperes.

NO'TE: Only a 4-conductor cord is to be used

when the appliance is installed in a mobile home

or where local codes do not permit grounding

through the neutral.

SfiPS

1. Locate connector block at the bottom rear of

range and remove rear wiring cover.

2. Directly below the connector block is a hole

with a knockout ring for accommodating conduit

fittings. Brackets provided are used to support

the flexible cord strain relief, which must be

securely attached to the cord set.

СТЕР 4

Power Cord Installation—Insert screws

through power cord terminals so that the screws

pass through connector block terminals and

engage nuts. Tighten screws securely.

POWER CORD

RING TERfvliNAL

_ _ POWER

" CORD

CONNECTOR

BLUUK

TERMINAL

Cable Direct Installation—Clamp bare wires

between the connector block terminals and

movable nuts with screws tightened seoirely

1. Copper Wiring

MOVABLE

NUT

SCREW

CONNECTOR

BLOCK

TERMINAL

FLEXIBLE

CABLE

Connect the neutral or grounded wire of the

supply circuit to the neutral terminal of the

connector block, located in the center. 'The

power leads must be connected to the outside

(brass colored) terminals.

NEUTRAL

TERMINAL

Ü ^

GROUNDING STRAP

(GROUNDING TO RANGE)

WARNING: CONNECTOR BLOCK IS

APPROVED FOR COPPER WIRE

CONNECTION ONLY.

1 2 ... 23 24 25 26 27 28 29 30 31 32

Comments to this Manuals

No comments

Ge 49-8255 User Manual Page 28

Comments to this Manuals

Related products and manuals for Radio Ge 49-8255