Ge Feb-50 User Manual download pdf (Page 11)

D. Reverse the HANDSET HOOK by firmly sliding it

out of cradle, rotating it 180° and sliding it back

into the cradle.

E. Remove the BACK COVER PLATE from the TELE

PHONE BASE UNIT by pushing in the two tabs.

F. If the wall jack is labelled Line 1-2, connect the

short TELEPHONE LINE CORD to the jack on

the telephone labelled LINE 1-2. If the wall jack

is labelled Line 3-4, connect the cord to the jack

on the telephone labelled LINE 3-4.

G. Thread the SHORT TELEPHONE LINE CORD

through the square hole in the center of the

BACK COVER PLATE.

H. Connect a LONG TELEPHONE LINE CORD to

the jack on the telephone labelled DC 9V.

I. Plug the AC POWER CORD into the jack on the

telephone labelled DC 9V.

Important: Do not plug the AC POWER CORD in

to an electrical outlet at this point.

J. Thread the long TELEPHONE LINE CORD and

the AC POWER CORD through the CHANNEL

on the back of the BACK COVER PLATE so that

the cords are taut at the top of the telephone,

(attach the BACK COVER PLATE to the BASE so

that the narrow end is at the top of the

telephone).

K. Hold the phone close to the wall jack and

connect the short TELEPHONE LINE CORD to

the jack.

L. Hold the telephone against the wall jack face

plate so the studs on the face plate slide into the

keyholes on the BACK COVER PLATE. Slide the

telephone down firmly so that it is locked secure

ly in place.

M. Connect either end of the COILED CORD to the

jack on the side of the TELEPHONE BASE UNIT.

Connect the other end to the jack in the HAND

SET. Place the HANDSET on the HANDSET

HOOK.

N. Connect the long TELEPHONE LINE CORD to

the jack by the baseboard.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

No comments

Ge Feb-50 User Manual Page 11