GE CT9070SHSS Instruction Manual download pdf (Page 6)

MOUNT THE OVEN

WARNING: Mounting screws must be used. Failure to do so could result in the

oven falling out of the cabinet, causing serious injury.

NOTE: During oven mounting step, ensure that no damage is done to oven gasket which lines the

edge of oven cavity.

NOTE: Before drilling the pilot holes, make sure the oven is pushed as far back into the opening as it

will go and is centered.

NOTE: If the cabinet is particle board, you must use #8 x ¾” particle board screws. These may be

purchased at any hardware store.

A. Drill through the mounting holes (top and bottom) of the side trim for the #8 mounting screws

provided.

B. Secure the oven cabinet with the screws provided.

BOTTOM TRIM INSTALLATION

• Slide oven out by 2” and attach the bottom trim through its mounting holes in front vertical brace

using two trim screws provided. Bottom trim lip must be placed under flange of bottom air duct.

Exercise caution while sliding the unit back in after bottom trim installation. Installer needs to ensure

that the trim does not catch the edge of the cabinet and bend. Furthermore, the installer needs to

ensure that the cabinet itself is not damaged while the unit is slid back into position.

WARNING

Do not slide oven out more than noted dimension, the unit can tip over and

fall causing serious injury & damage.

The Screws Must

Be a Minimum of

¼” (6 mm) From

the Front of the

Cutout.

SWO’s installation

Mounting

Hole

Locations

(hole locations

may vary)

Keep Bottom Cabinet Trim to the

Inside of the Side Cabinet Trims

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

No comments

GE CT9070SHSS Instruction Manual Page 6