GE BL Series Installation Guide download pdf (Page 5)

Plug together wires between luminaires.

Join mounting brackets together with M4 hex head screw

and nut. Also tighten wingnuts. Make sure that there is no

visible gap between xtures. Slightly reposition brackets

and join them again to have proper t.

Note for City of Chicago: Luminaires are designed to meet City of Chicago Environmental Air (CCEA) requirements. During installation,

in any case where the opening between the xtures exceeds the 0.05” CCEA requirement, a sealant tape can be applied over the

opening. Tape has to meet the requirements of UL181A-P and UL181B-FX standards and meet requirements for UL-723.

Carefully align pins of one luminaire with grooves of next

luminiare, then push them completely together, taking

care not to pinch wires.

Note: A rubber mallet may be required to complete this

step. Hammer the luminaires only on the top edge, not

the bottom.

For added safety, use additional ceiling grid screws to

permanently x brackets to grid.

One safety screw per

bracket is mandatory,

additional screws are

optional

WARNING

Risk of Injury. Improper mounting bracket installation

may cause injury or property damage.

Diffuser Installation

1A 1B

Option - two diffusers (primary and anti-glare): Tilt

and slide both diffusers into base of luminaires, making

sure the diffuser with the green protective lm is placed

on the bottom (remove lm rst). The last diffusers will

need to be trimmed to t in Step 2.

Option - one diffuser (primary): Tilt and slide diffusers

into base of luminaires. The last diffuser will need to

be trimmed to t in Step 2.

Bottom: Anti-glare diffuser with

green lm faces up. Remove

before sliding in.

Primary diffuser

Top: Primary diffuser with no lm

1 2 3 4 5 6

No comments

GE BL Series Installation Guide Page 5