Ge ZVC42LSS User Manual download pdf (Page 14)

Plan the Location of the Hood and Ductwork

The ceiling structure must be capable of supporting the

weight of the insert sleeve (approximately 100 pounds),

the canopy itself, any mounting hardware and any

inadvertent user contact loads.

• Use a plumb bob to check the location.

Thecountertop/cooktop below the insert sleeve must

be centered with the insert sleeve.

• If desired, install the control in a remote location

using the supplied mounting hardware. See the

following pages for detailed instructions for

mounting the control remotely.

• Refer to Ceiling Ducting on page 13 for ductwork

installation.

IMPORTANT: The exhaust outlet in the top of the

insert sleeve is not centered; it is positioned closer

to the back side. Therefore, the insert sleeve may

not be centered front to back in the canopy. A

custom liner constructed by the cabinet supplier

is usually required for island installations.

NOTE: It is recommended that the custom hood

insert be purchased and on-site before the canopy

is constructed.

CONSTRUCT CEILING SUPPORT (for Island Installation)

Island Installation Preparation

Ceiling

Hood

ducting

centerline

Countertop

Front

Front view

Align with

center of

cooktop

*30" Minimum required

*36" Maximum

recommended

installation height

Cooktop

* Always refer to the cooktop or range installation

instructions for product-specific clearances.

• The insert sleeve in the canopy must be centered

left to right over the cooktop.

Left side view

*30" Minimum required

*36" Maximum recommended

installation height

Illustrations not to scale

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 67 68

Comments to this Manuals

No comments

Ge ZVC42LSS User Manual Page 14

Comments to this Manuals

Related products and manuals for Hoods Ge ZVC42LSS