Ge ZV925SLSS User Manual download pdf (Page 12)

• Align the template with the marks on the ceiling

and tape in place.

– Be sure the template is oriented correctly with the

front of the hood.

• Use a plumb bob to be sure the mounting holes

will provide parallel alignment with the countertop

below.

• Center punch all hole locations.

• Drill pilot holes in the 4 screw locations. Use a 3/16"

bit and drill approximately 1-1/2" deep.

• Drive 4 hex head wood screws into the center of

the ceiling joists and cross framing. Leave a 1/4"

gap to allow the screw head to engage the keyhole

slots on the support frames.

• Cut the 8-1/2" duct opening through the sheet rock.

STEP 1 MOUNT TEMPLATE

Installation Instructions

STEP 2 ADJUST FRAME HEIGHT

•Measure exact ceiling height.

• Find the exact frame height

required on the chart on page 6.

• Remove 2 screws on each of the

4 sides of the frame to loosen the

upper structure, lower structure

and blower/motor.

• Adjust the height “X”, according to

the chart on page 6. Use a total of

32 screws (8 screws on each side)

to secure the upper structure,

lower structure and blower/

motor together.

1/4" Gap

24"min.

30"max.

36"min.

Frame

height

2-3/4"

Ceiling

height

49-80406

Printed in Italy 04-06 JR

36≤ Hood

Template

8-1/2

≤

Dia.

Cut a 1≤Dia.

Wire Access

Hole

Cut a 1≤Dia.

Wire Access

Hole

Drill 3/16≤

Pilot Holes

Approx. 1-1/2≤

Deep

Drill 3/16≤

Pilot Holes

Approx. 1-1/2≤

Deep

10-1/16≤ to

Centerline

of Holes

7-1/16≤ to

Centerline

of Holes

FRONT OF HOOD

7-1/16≤ to

Centerline

of Holes

,167$//$7,21³9(17('727+(2876,'(

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

Comments to this Manuals

No comments

Ge ZV925SLSS User Manual Page 12

Comments to this Manuals

Related products and manuals for Hoods Ge ZV925SLSS