Ge JGAS02SENSS User Manual download pdf (Page 7)

ge.com

Safety Instructions Operating Instructions Care and Cleaning Installation Instructions Troubleshooting Tips Consumer Support

READ AND FOLLOW THIS SAFETY INFORMATION CAREFULLY.

SAVE THESE INSTRUCTIONS

SURFACE BURNERS (cont.)

■ When a pilot goes out (on standing pilot

models), you will detect a faint odor of gas

as your signal to relight the pilot. When

relighting the pilot, make sure burner

controls are in the off position, and follow

instructions in this book to relight.

■ If you smell gas, and you have already

made sure pilots are lit (on standing pilot

models), turn off the gas to the range and

call a qualified service technician. Never

use an open flame to locate a leak.

■ Do not place or store items that can melt

or catch fire on the grates, even when the

cooktop is not being used.

■ Keep range clean and free of

accumulations of grease or spillovers,

which may ignite.

Do not locate the range where it may be subject to strong drafts. Any openings in the floor or wall

behind the range should be sealed. Make sure the openings around the base of the range that supply

fresh air for combustion and ventilation are not obstructed by carpeting or woodwork.

FLOORING UNDER THE RANGE

Your range, like many other household items,

is heavy and can settle into soft floor coverings

such as cushioned vinyl or carpeting. Use

care when moving the range on this type of

flooring. It is recommended that the following

simple and inexpensive instructions be

followed to protect your floor.

The range should be installed on a sheet of

plywood (or similar material). When the floor

covering ends at the front of the range, the

area that the range will rest on should be built

up with plywood to the same level or higher

than the floor covering.

This will allow the range to be moved for

cleaning or servicing. Also, make sure your

floor covering will withstand 180°F. (See the

Installation Safety Instructions section).

Make sure the wall coverings around your

range can withstand the heat generated (up to

200°F) by the range. (See the Installation

Safety Instructions section).

Leveling legs are located on each corner of

the base of the range. Your range must be

level in order to produce proper cooking and

baking results. After it is in its final location,

place a level horizontally on any oven shelf

and check the levelness front to back and

side to side. Level the range by adjusting the

leveling legs or by placing shims under the

corners as needed.

LEVELING THE RANGE

1 2 3 4 5 6 7 8 9 10 11 12 ... 35 36

Comments to this Manuals

No comments

Ge JGAS02SENSS User Manual Page 7

Comments to this Manuals

Related products and manuals for For Home Ge JGAS02SENSS