Ge Monogram ZV755 User Manual download pdf (Page 10)

INSTALL MOUNTING BRACKETS

The vent hood must be secured to rear support framing

or a wall stud.

• With the template taped in place, use a punch to mark all

mounting screw locations.

• Drill 1/8″ pilot holes at the 6 punched locations.

• Remove the template.

• Enlarge holes that did not enter studs to 3/8″ and tap

anchors for wall fasteners into the holes.

– Drive screws into the fasteners to allow anchors to

expand against the wall material. Remove the screws

for final installation.

• Secure the mounting brackets to the wall studs with

wood screws provided.

Installation Instructions

INSTALLATION – VENTED TO THE OUTSIDE

NOTE: Screws “A” and “B” are preassembled onto the

brackets. Do not remove these screws.

INSTALL THE HOOD

Place the hood on the brackets and slide left to right to align

with rectangular slots at the top.

• Adjust the installation height by tightening or loosening

the screws “A” at the bottom of the brackets.

• Align the hood lower mounting holes with pilot holes in the

wall.

• Using two large washers (supplied), install wood screws or

wall-fastener screws, loosely, into lower mounting holes.

Do not tighten.

• Level the hood by tightening or loosening the screws “A”

located on the bottom mounting brackets.

• Tighten the lower mounting screws.

• Tighten screws “B” located at the top of the mounting

bracket against the hood to adjust position. Do not

overtighten screws.

Screws “B” to adjust

hood against wall

Level and height

adjustment

screws “A”

Lower mounting

screws

Screws “B”

Screws “A”

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 55 56

Comments to this Manuals

No comments

Ge Monogram ZV755 User Manual Page 10

Comments to this Manuals

Related products and manuals for Fans Ge Monogram ZV755