Ge Monogram ZV755 User Manual download pdf (Page 4)

Advance Planning

DUCTWORK PLANNING

•This hood is designed to be vented vertically

through the ceiling. Use locally supplied elbows

to vent horizontally through the rear wall.

•Determine the exact location of the vent hood.

•Plan the route for venting exhaust to the outdoors.

•Use the shortest and straightest duct route

possible. For satisfactory performance, duct run

should not exceed 100′ equivalent length for any

duct configurations.

•Refer to “Duct Fittings” chart to compute the

maximum permissible length for duct runs to

the outdoors.

•Use rigid metal ductwork only.

•This vent hood must use a 6″ round duct. The

6″ round duct can transition to 3-1/4″ x 10″

or 3-1/4″ x 12″.

•Install the house duct to run horizontally between

ceiling joists or straight up through the roof.

•Install a wall or roof cap with damper at the

exterior opening. Order the wall or roof cap

and any transition and length of duct needed

in advance.

WARNING: TO REDUCE THE RISK OF FIRE,

USE ONLY RIGID METAL DUCTWORK.

WALL FRAMING FOR ADEQUATE

SUPPORT

•This vent hood is heavy. Adequate structural

support must be provided. The hood must be

secured to vertical studs in the wall. See page 9

or 14.

•We strongly recommend that the vent hood with

duct cover be on site before final framing and wall

finishing. This will also help to accurately locate

the ductwork and electrical service.

•Installation will be easier if the vent hood is

installed before the cooktop and countertop are

installed.

ADVANCE PLANNING

A duct cover accessory may be required for your

hood installation depending on ceiling height.

1 2 3 4 5 6 7 8 9 ... 55 56

No comments

Ge Monogram ZV755 User Manual Page 4