GE JVE40DTBB Owner's Manual download pdf (Page 12)

49-80622-5

CHOOSE VENTING OPTION

The hood can be set to vent outside or to recirculate air

back into the kitchen.

• To vent to the outside, refer to steps 5 and 6.

• To recirculate air into the kitchen, remove two

screws securing the duct block off plate. Discard

plate. Replace two screws.

Note: Hood is ENERGY STAR

certified only when it vents

air to the outside.

Installation Instructions

CUT HOLES

Cut holes at marked locations for duct and electrical

wiring. For the vertical duct, cut out 3/4” extra toward

the front of the cabinet so you can move the duct

freely when installing the hood. It may also ease

installation by cutting the hole 10

ø2” instead of 10”.

FOR RECESSED-BOTTOM CABINETS

ONLY

Wood shims

• If the cabinets have front, side or back trim, make

2 wood shims the width of the trim and attach them to

the cabinet bottom recess on both sides. See Step 7 for

marking locations.

RUN WIRES

Run the electrical wires through the wall or cabinet

according to National Electrical Code and applicable

local codes.

NOTE: DO NOT turn the power on until installation is

complete.

SCREW IN PARTWAY

Drive a mounting screw (from the hardware packet)

partway into each center of the narrow neck of the

keyhole slots marked on the cabinet bottom.

FEED IN WIRES

Lift the hood into position and feed the house

wiring through the wiring knockout.

SECURE HOOD

Slide the hood back against the wall. Tighten the

mounting screws. Be sure the screw heads are in

the narrow neck of the keyhole slot.

Keyhole (4)

OPTIONAL POWER CORD KIT JXHC1

Use only with range hood cord-connection kits that

have been investigated and found acceptable for

use with this model range hood.

For installation with a standard 3-prong, grounded

wall outlet, Power Cord Connection Kit model

JXHC1 must be used. This kit contains a power

cord and the hardware required to connect it

to the range hood. It is available at extra cost

from your GE supplier. Follow the Installation

Instructions packed with the kit.

NOTE: If using optional Power Cord Kit JXHC1, feed

the power cord through the hole in the top cabinet

while raising the hood. Loop any excess length of

cord and tie away with a suitable tape or tie.

Cabinet

ø4s

3-prong

wall outlet

(if using cord

connection)

ø4s

ø4sdia. clearance hole

for optional power

supply location

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 31 32

Comments to this Manuals

No comments

GE JVE40DTBB Owner's Manual Page 12

Comments to this Manuals

Related products and manuals for Cooker hoods GE JVE40DTBB