Ge 49-7400 User Manual download pdf (Page 15)

Consumer SupportTroubleshooting TipsOperating InstructionsSafety Instructions Installation Instructions

Through the Wall Installation Instructions–Optional.

IMPORTANT

Through the wall installation is not appropriate

if any of the side louvers in the case will be

obstructed by the wall.

All side louvers in the case must project on the

outdoor side of the wall.

The room side of the case must project into the

room at least 1

⁄

″

from the finished wall.

The case must be installed level from side-to-side

and with a slight tilt from front to rear. Use a level;

about a 1/2 bubble will be the correct case slant to

the outside.

Remove the air conditioner from the case.

For specific instruction, refer to the

Window

Installation Instructions

Make certain a wall receptacle is available

close to the hole location or make

arrangements to install a receptacle.

Place the case in the wall opening and

secure with 12 1″ long #10 wood screws.

NOTE: Drill pilot holes, if necessary, for proper

installation. If the frame is oversized, use shims

to prevent case distortion.

The case may be installed through the wall in both existing and new construction.

Read completely, then follow step-by-step.

Caulk all four sides on the outdoor side of the case to prevent moisture from getting through to the

interior wall. Use of flashing (drip rail) will further prevent water from dripping inside the wall and

down the outside of the building.

Lintel angle (if required)

Caulking

Air louvers

(must project on

the outdoor side

of the wall.)

Wood Filler and Caulking

(above & below the flashing)

Flashing (Drip rail)

4.5 cm (1

/4″) min.

Bottom rail

INSIDE

OUTSIDE

Trim molding (if desired)

Plaster line

Finish the Wall Opening

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

Ge 49-7400 User Manual Page 15

Comments to this Manuals

Related products and manuals for Conditioners Ge 49-7400