Ge 49-7400 User Manual download pdf (Page 13)

Consumer SupportTroubleshooting Tips

Operating InstructionsSafety Instructions

Installation Instructions

Install the Case in the Window

Cut the window sash seal to the window width

and stick the adhesive side to the bottom of

the sash.

Thread two type C bolts into the support

brackets.

Slide the case into the window and lower the

window behind the top mounting rail.

Position the brackets on the case bottom so

they will be near the outermost point on the

window sill. Attach the support brackets to

each side of the case bottom using 4 type A

screws on each side. The case should be

slightly tilted to the outside. Use a level;

about a 1/2 bubble will be the correct case

slant to the outside.

Locate the 3 screw holes along the bottom front

edge of the case. Center the case, side to side,

in the window and mount it to the window sill

using 3 type B screws.

Extend the left and right accordion panels to

the vertical window sashes and attach with 4

type B screws.

Window sash seal

Type B

screws

Type B

screws

Top mounting rail

Type B screws

Install the Security Bracket and the Foam Top Window Gasket

Attach the security bracket with a type B screw. Cut the foam top window gasket to the

window width.

Stuff the foam between the glass and the

window to prevent air and insects from getting

into the room.

Type C bolts

Type A screws

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

No comments

Ge 49-7400 User Manual Page 13