GE NX-116E User Manual download pdf (Page 14)

OTHER KEYPAD FUNCTIONS

SETTING THE KEYPAD TONE

Step 1 Press [r]-[0]. Keypad is now in the “Adjust Tone” mode.

Step 2 Pressing the [1] key will make the keypad sounder go to higher

tones, pressing the [2] key will make the keypad sounder go to lower

tones.

Step 3 When the desired tone is reached, press the [#] key to set this tone

and exit from the “Adjust Tone” mode.

CHANGE PARTITION – Optional

Step 1 Press [r]-[1].

Step 2 Press a NUMBER key (1 or 2) to change partitions momentarily.

Step 3 If no other key is pressed, it will go back to its standard partition in

ten seconds.

Step 4 If another key is pressed, the system will remain in the new partition

until no keys have been pressed for 60 seconds.

VIEW ALARM MEMORY

Step 1 Press [r]-[3]. The zone(s) that created the last alarm will be

displayed on the keypad.

Step 2 The ALARM MEMORY feature will flash those zones that created

alarms and will light steady those zones that were bypassed during

the last alarm.

TEST FUNCTION – Optional

If programmed, this function will perform a battery test, communicator test, and/or

a siren test. No alarms will be sent and no reports will be sent unless a

communicator test is performed, at which time a test signal will be sent.

Step 1 Press [r]-[4]. The test will be performed as programmed.

Step 2 If the siren test is performed, enter a user code to silence the siren.

WALK TEST

If enabled, it will permit a temporary walk-through test where all zones become

silent and do not report alarms to the central station.

Step 1 Press [r]-[Chime]-[user code]. During this test the chime light will

flash on the LED keypad.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

No comments

GE NX-116E User Manual Page 14