GE 24962 User Manual download pdf (Page 3)

Battery Installation

1. On the back of the remote, push down on the

tab and lift the cover off.

2. Match the batteries to the + and - marks inside

the battery case, then insert 2 AAA Alkaline

batteries.

3. Press the battery cover back into place.

Battery Saver

Your remote automatically turns off if the buttons

are depressed more than 30 seconds. This will

save your batteries should your remote get stuck in

a place where the buttons remain depressed (e.g.,

between the sofa cushions).

Code Saver

You will have up to 10 minutes to change the

batteries in your remote without losing codes you

have programmed. However, do not press any

buttons until batteries are installed in the remote.

If buttons are pressed without batteries in the

remote, all codes will be lost.

Code Setup

The SETUP button is used to setup the remote.

You can either setup the remote using the code

for your brand of product, from the code tables (on

separate sheet), or you can search through the

library of codes until you nd a code that works for

your product. Please refer to “Code Search” page

8 for more information on using the code search

feature to learn how to search through the library

of codes for your products. NOTE: You can store

any kind of code under any mode (except TV). I.e.,

you can store a DVR code under the SAT/CBL

button, or a cable code under the DVD button, etc.

However, you can only store TV codes under the

TV button.

 Setup

1 2 3 4 5 6 7 8 ... 15 16

No comments

GE 24962 User Manual Page 3