ADVANCED CONFIGURATION
Some Z-Wave devices provide advanced capabilities available only
through the use of a remote control like the 45601 Advanced Remote.
One example is the 45606 in-wall dimmer which allows the end user to
create 3 different dim rates depending upon how the dimmer is activated
(manually, via a normal Z-Wave “Dim” command or via an All-On or All-Off
Z-Wave command). Each of the three can be set anywhere between 10
milliseconds and 4.2 minutes for the time it takes to go from full intensity to
minimum intensity.
Please refer to the instructions of your Z-Wave device for available options
and specific instructions on changing its advanced configuration.
To Change Advanced Configuration Settings:
Press and hold SETUP the screen displays LGHT SETUP.
Use either Arrow key to scroll until the display reads ADV CONFIG.
Press OK and screen will display PARAM 0.
Use either Arrow key to scroll until the display reads the proper
parameter number (1 - 255) as indicated in the Z-Wave device’s
instructions.
Press OK and the screen will read NUM BYTES.
6. Use either Arrow key to scroll until the display reads the proper
number of bytes (1, 2 or 4) as indicated in the Z-Wave.
device’s instructions.
7. Press OK and the screen will display read CONFIG VAL.
8. Use either Arrow key to scroll until the display reads the proper value
(0 - 255) as indicated in the Z-Wave device’s instructions.
9. Press OK.
10. Press the button on the device.
11. The screen will display SUCCESS.
SENDING INFORMATION TO A SECONDARY REMOTE
You can add a secondary remote to your network, and copy your primary
remote’s network and device information to it.
To send information to a secondary remote:
Place the two remotes near each other.
Press and hold SETUP on the primary 45601 Advanced remote until
the display reads LGHT SETUP.
Use either Arrow key to scroll until the display reads TRANSFER.
Press OK and the screen will display PRIMARY.
Use either arrow key to scroll until the display reads SECONDARY.
Press OK and the Screen will display ALL.
a. To send network and device information to the new remote,
proceed to Step 7.
b. To send only network information to the new remote, use either
arrow key to scroll to NTWK ONLY and proceed to Step 7.
7. Refer to the user manual for the secondary remote for
programming information. Put the target (secondary) remote into
programming mode so that it receives information from the primary
remote. See the following section on “Copying Information to this
Remote” if the target remote is a 45601 remote.
8. Press the OK key and the screen will display SENDING.
9. When screen displays SUCCESS you have successfully transferred
the information.
1.
2.
3.
4.
1.
2.
3.
4.
5.
6.
(14 pages)
(28 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals