GE SV-60 Operations Manual download pdf (Page 7)

www.ge.com/inspectiontechnologies

System Setup and Operation

CAUTION:

1. Verify that the supply voltage is within the 100-240VAC range specified for this product.

2. To prevent temporary blinding, insert light guide into socket before turning power ON.

3. The light guide tip and light source socket will be hot when light guide is removed.

CONTROLS & PORTS

ON/OFF Switch

A two position rocker switch is used to turn the unit on or off. Depressing the side marked

with a ( I ) turns the unit on, while depressing the side marked with an ( £ ) turns it off.

Light Intensity Control Knob

This knob on the front panel rotates to adjust the amount of light transferred into the light

guide. Rotating the ring clockwise will increase the amount of light in the image and rotating

the ring counter clockwise will decrease the amount of light. This manual control is helpful

when trying to better illuminate one part of the image or when trying to reduce blooming.

Light Exit/Light Guide Socket

Socket will accept Olympus style adapter.

Video-In Camera Port

When using a borescope with the BCAM C-Mount Camera, the BCAM power/video cable con-

nects to the light source here. It carries power from the light source to the camera, and brings

the camera video back to the light source video channel. It can not be used with cameras

other than the BCAM.

Video-Out Ports

When using a borescope with the BCAM C-Mount Camera, the camera video is accessed at

either of these ports. Connect either an S-Video or composite BNC cable from the appropri-

ate output port to a monitor for display, or other peripheral device for recording.

6 ELSV-60 Light Source

1 2 3 4 5 6 7 8 9 10 11 12 ... 17 18

No comments

GE SV-60 Operations Manual Page 7