GE NEMA Premium Efficient XsD Ultra Instruction Sheet download pdf (Page 3)

GEK-99908

3

Installation Instructions for Inpro™ Seal Kit

For Severe Duty Motors Only

I. Remove the slinger from the drive

endshield

II. Slide the Inpro Seal over the shaft extension

on the drive end until the seal rests firmly

against the endshield inside the recessed slinger

cavity. The O-ring on the OD of the seal goes

against the motor. See Figure 3.

III. If the keyway extends under the O-ring of

the Inpro Seal, the gap should be filled with

RTV.

IV. RENAMEPLATING

A. Stamp the Inpro Seal identification

letters “R2L” directly above the model number

on the motor nameplate as illustrated below in

Figure 2. On the 182-186 frame motors, the

letters will not fit after the model number, so

they should be stamped directly above the

model number as shown below in Figure 1.

B Stamp your GE buyer identification

letters at the far right of the motor nameplate

after the date code. To secure your GE buyer

identification letters, contact the Fort Wayne

Customer Service Center at 1-800-327-4883.

C. Failure to stamp the GE buyer

identification letters or the Inpro Seal

identification letters on the nameplate VOIDS

the warranty on the motor and its components.

Figure 1: 182-286 Frames

Figure 2: 324-449 Frames

Figure 3: Inpro Seal Installation

IV. PARTS SUPPLIED

1 Inpro™ Seal

1 Instruction Sheet GEK-99908

R2L

Model 5KS182SE205B HP No AB

Mod GE Buyer

Letters Identification #

Mod GE Buyer

Letters Identification #

Model 5KS324SS204AR2L HP No AB

1 2 3 4 5 6 7

Comments to this Manuals

No comments