GE GPS12FGHWW Use and Care Manual Page 11

  • Download
  • Add to my manuals
  • Print
  • Page
    / 52
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 10
9
REHANG THE FREEZER DOOR
Transfer the
screw cover on
top of the door to
the opposite side.
Place the freezer
door on the center hinge over the pin. Assure the door
is aligned horizontally and vertically, and that the gasket
seals on all sides.
Attach the top hinge removed earlier on the left side of
your refrigerator and replace the hinge cover
7
TRANSFER TOP HINGE TO THE LEFT
Using a putty knife with the edge covered with
masking tape, remove the screw cover on the left.
Be careful of the
paint finish.
Reinstall the screw
cover on the right
side.
REVERSING THE DOOR SWING (CONT.)
Installation Instructions
11
4
TRANSFER FRESH FOOD DOOR STOP
TO THE LEFT
Remove the door stop from the bottom of the right
side of the door. Transfer the screw covers from the
bottom left side to the right side.
Using the left door stop included with the parts that
came with your refrigerator, install the left door stop.
5
REHANG THE FRESH FOOD DOOR
Make sure the washer(s) are in place on the bottom
hinge pin. Make sure the door is aligned horizontally
and vertically. Place the fresh food door on the bottom
hinge, close the door and tape it in place with
masking tape.
Remove the screw covers from the left edge of the
door and insert it into the hole on the opposite side.
6
I
NSTALL CENTER HINGE ON THE LEFT
Remove the three screw covers on the left side and
install two of them on the right.
Using the middle hinge and screws (and washers if
applicable) removed earlier, install the left middle hinge
on the left side.
Remove the tape
holding the door
shut.
CAUTION
When assembled correctly, the
hinge is tight against the cabinet.
Screw Covers
Screw Cover
ATTENTION: The
screws must be
properly tightened.
Turn the screws until
snug. Then tighten the
screws a minimum of
1/2 turn using both
hands.
6
INSTALL CENTER HINGE ON
THE LEFT (CONT.)
8
TRANSFER FREEZER DOOR STOP
TO THE LEFT
Remove the door stop from
the bottom of the right side of
the door. Transfer the screw
covers from the bottom left
side to the right side.
Using the left door stop
included with the parts that
came with your refrigerator, install the left door stop.
Page view 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 51 52

Comments to this Manuals

No comments