GE 197D5616P001 User Manual download pdf (Page 9)

Safety Instructions

Operating Instructions

Troubleshooting Tips

Consumer SupportInstallation Instructions

Preparing to install the refrigerator.

Read these instructions completely and carefully.

Turn counterclockwise to raise,

clockwise to lower.

Refrigerator Location

■ Do not install the refrigerator where the temperature will go below

50°F (10°C) because it will not run often enough to maintain

proper temperatures.

■ Install it on a floor strong enough to support it fully loaded.

■ If the 2 cubic foot model is placed on a countertop or stand,

the front surface of the door should be 3″ or more back from the

edge of the countertop or stand to avoid accidental tipping of the

appliance during normal use.

■ Do not install it closer than 5″ (13 cm) next to a range.

The following applies only to the 2, 3 and 4 Cubic Foot Models:

■ Do not install it in a recessed area.

■ Do not build in the refrigerator.

Clearances

Allow the following clearances for ease of installation and proper

air circulation.

2, 3 and 4 6 Cubic Foot

Cubic Foot Models Model only

Sides 1/2″ (13 mm) 0″ (0mm)∗

Top 2″ (51 mm) 0″ (0mm)

Back 2″ (51 mm)** 0″ (0mm)

*1-1/4″ (32 mm) for hinge side clearance

**From the rear cabinet surface to the wall

Leveling Legs (on some models)

Adjustable legs at the front corners of the refrigerator

should be set so the refrigerator is firmly positioned on

the floor and the front is raised just enough that the

door closes easily when opened about halfway.

To adjust the leveling legs, turn the legs counterclockwise

to raise the refrigerator, clockwise to lower it.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

No comments

GE 197D5616P001 User Manual Page 9