Connect ground lead to the green lead, green ground
screw on housing or terminal block provided.
Do not remove insulated connectors from wires not needed
for required voltage connection.
IF SINGLE VOLTAGE:
All single voltage ballasts are pre-wired such that user need
only connect the supply conductors.
IF MULTIVOLT: (120/208/240/277 volts)
Connect the ballast lead with the insulated terminal to the
desired voltage terminal as indicated on the ballast terminal
nameplate.
MAINTENANCE
CAUTION
Risk of burn
• Allow lamp/fixture to cool before
handling
WARNING
Risk of burn
• Do not touch operating luminaire
It will occasionally be necessary to clean the outside of
the refractor to maintain the light level. Frequency of
cleaning will depend on the ambient dirt level and the
minimum light level which is acceptable to the user. The lens
door should be washed in a solution of warm water and any
mild, non-abrasive household detergent, rinsed with clean
water and wiped dry. Should the optical assembly become
dirty on the inside, wipe the reflector and clean the lens
door in the above manner and replace any damaged
gaskets.
Periodic cleaning on the outside of the door glass will
ensure operation at maximum optical efficiency. The glass
and reflector (if needed) should be cleaned with non-abrasive
soap, cleaner, or detergent solutions, rinsed with cold water
and wiped dry.
The light output is also dependent on the age of the
lamp. In applications where the light level is critical, it may
be desirable to replace lamps before they burn out. The lamp
manufacturer can provide data showing how the lamp light
output decreases with use.
LAMP INSTALLATION/REPLACEMENT
Use only lamps specified on nameplate. Observe lamp
manufacturer’s recommendations and restrictions on lamp
operation, particularly ballast type, burning position, etc.
Lamp Tightness – Mogul Base Lamp: The lamp should be
securely inserted to the NEMA-EEI specified torque of 35 inch-
pounds, which is best achieved by very firmly tightening to
insure application of sufficient torque. Tightening must be
sufficient to fully depress and load the center contact of the
socket.
QL induction lamps require assembly. Insert lamp onto
power coupler until lamp "clicks". Turn clockwise until second
"click" to lock.
NOTE: Lamp/coupler must be mounted on socket bracket
PRIOR to attaching to the reflector skirt.
Rain Shield Installation Instructions (for V3ST)
1. Silicone Seam Two Places
2. Place Rain Shield On Top Of Existing Fixture
3. Fasten with #10 Self Tapping Sheet Metal Screws Four Places
#10 SELF TAPING SHEET METAL SCREWS FOUR PLACES
RAIN SHIELD
SEAM TWO PLACES
FIRST STEP,
SLIP SHIELD THROUGH FITTER
(SEE BOTTOM ILLUSTRATION
BEFORE CONTINUING.)
FITTER
SECOND STEP,
INSTALL #10 SHEET METAL SCREWS IN TEN PLACES.
USE PRE-HOLES ON SHIELD.
(SEE BOTTOM ILLUSTRATION BEFORE CONTINUING.)
THIRD STEP,
SLIP FIXTURE ONTO MOUNTING
SHAFT AND FASTEN WITH SET
SCREWS AND THROUGH BOLT AS
ILLUSTRATED.
AFTER SLIPPING SHIELD ONTO FIXTURE FITTER, MAKE
SHIELD TANGENT TO FIXTURE IN THREE PLACES AS
SHOWN BELOW BEFORE FASTENING IN PLACE.
COMPLETE ASSEMBLED ILLUSTRATION
Dark Sky Shield Installation Instructions (for V3ST)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals