GE JVM1790 User Manual download pdf (Page 21)

Attach the oven to the top cabinet.

Cabinet Front

Cabinet Bottom Shelf

Filler Block

Oven Top

Equivalent to Depth

of Cabinet Recess

Installation Instructions

MOUNT THE OVEN

C4.

FOR EASIER INSTALLATION AND PERSONAL

SAFETY, WE RECOMMEND THAT TWO PEOPLE

INSTALL THIS OVEN.

IMPORTANT: Do not grip or use handle

during installation.

NOTE: If your cabinet is metal, use the nylon

grommet around the power cord hole to prevent

cutting of the cord.

NOTE: We recommend using filler blocks if the

cabinet front hangs below the cabinet bottom shelf.

IMPORTANT: If filler blocks are not used,

case damage may occur from over tightening

screws.

Insert a self-aligning screw through top center

cabinet hole. Temporarily secure the oven by

turning the screw at least two full turns after the

threads have engaged. (It will be completely

tightened later.) Be sure to keep power cord

tight. Be careful not to pinch the cord, especially

when mounting flush to bottom of cabinet.

Self-Aligning Screw

Rotate front of oven

up against cabinet

bottom.

NOTE: When mounting the

oven, thread power cord

through hole in bottom of

top cabinet. Keep it tight

throughout Steps 1–3. Do

not pinch cord or lift oven

by pulling cord.

Lift oven, tilt

it forward, and hook

slots at back bottom

edge onto four lower

tabs of mounting

plate.

Place the blower unit back into the opening.

CAUTION: Do not pull or stretch the blower unit

wiring. Make sure the wires are not pinched.

ADAPTING BLOWER FOR

RECIRCULATION

(continued)

C3.

Replace blower plate with the screws removed in

Step 1.

Secure blower unit to oven with the screw

removed in Step 2. Insert the screw in bottom

right screw hole on the back of the oven.

Blower Motor

Screw

Blower Plate Screws

Back of Oven

1 2 ... 16 17 18 19 20 21 22 23 24

Comments to this Manuals

No comments

GE JVM1790 User Manual Page 21

Comments to this Manuals

Related products and manuals for Flat panel ceiling mounts GE JVM1790