GE Free-Standing Electric Ranges User Manual download pdf (Page 8)

Installation Instructions

INSTALL THE RANGE

ANTI-TIP DEVICE INSTALLATION

An Anti-Tip bracket is supplied with

instructions for installation in a variety of

locations. The instructions include all

necessary information to complete the

installation. Read the Safety Instructions

and the instructions that fit your situation

before beginning installation.

WARNING:

• Range must be secured by Anti-Tip bracket

supplied.

• If the Anti-Tip device supplied with the

range does not fit this application, use the

universal Anti-Tip device WB2X7909.

• See instructions to install (supplied with bracket).

• Unless properly installed, the range could

be tipped by stepping or sitting on the door.

Injury may result from spilled hot liquids

or from the range itself.

Typical installation of anti-tip bracket attachment to wall

Bracket

Screw must

enter wood

or metal

Wall plate

REPLACE THE WIRE COVER

Replace the wire cover on the range back

by sliding its left edge under the retaining

tabs and replacing the five screws removed

earlier. Make sure that no wires are pinched

between the cover and the range back.

REMOVE STORAGE DRAWER

ON MODELS WITHOUT BAKING

OR WARMING DRAWERS

Pull the drawer out until it stops.

Lift the front of the drawer until the

stops clear the guide.

Remove the drawer.

Stop

Wire

cover

5 screws to

replace wire cover

Retaining

tabs

Back of

range

PREPARE TO LEVEL MODELS

WITH BAKING OR WARMING

DRAWERS

Measure the height of your countertop

at the rear of the opening (X).

Adjust two rear leveling legs so that the

rear of the cooktop is at the same height

as the counter (Y).

Slide unit into place.

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

GE Free-Standing Electric Ranges User Manual Page 8

Comments to this Manuals

Related products and manuals for Electrical wallplates GE Free-Standing Electric Ranges