Ge DCD330G User Manual download pdf (Page 7)

Tools and Materials Required for Dryer Installation

Using the four shipping carton corner posts (two

on each side), carefully lay the dryer on its left

side and remove foam shipping pad.

CAUTION:

To prevent damage, do not use the

control panel as a means to pick up or move

the dryer.

Return the dryer to an upright position.

Adjust the leveling legs to match the washer

height. The dryer must be level and rest firmly

on all four leveling legs.

Preparing to install your dryer.

Read these instructions completely and carefully.

WARNING

■ This dryer must be exhausted to the outdoors

using only rigid metal or flexible metal 4″

diameter ductwork for inside the dryer cabinet

or exhausting.

■

Never use plastic or other combustible ductwork.

See Exhausting section.

■ This appliance must be properly grounded

and installed as described in these

Installation

Instructions.

■ Do not install or store appliance in an area where

it will be exposed to water/weather. See

Location

of Your Dryer

section.

■ The National Fuel Gas code restricts installations

gas appliances

in garages. They must be 18″

(45.7 cm) off the ground and protected from

vehicles by a barrier. See

Location of Your Dryer

section.

■ The

electrical service

to the dryer must conform

with local codes and ordinances and the latest

edition of the National Electrical Code,

ANSI/NFPA 70.

■ The

gas service

to the dryer must conform

with local codes and ordinances or the latest

edition of the National Fuel Gas Code ANSI

Z223.1. The gas dryer is designed for use under

ANSI Z 21.5.1. This dryer is not recommended

for commercial applications such as restaurants

or beauty salons, etc.

Unpacking the Dryer

Foam shipping pad

Packing

Electric Dryer

■ Channel-lock pliers (adjust leveling legs)

■ 1/2″ open-end wrench (lock leveling legs)

■ Carpenter’s level

■ Rigid or flexible metal 4″ (10.2 cm) duct

■ Duct tape

■ Vent hood

■ 1/4″ nut driver (remove terminal block access

cover and install cord)

■ Flat or straight blade screwdriver (may be needed

for cord strain relief)

■ UL approved 30A, 240V, 3-wire, #10 AWG

minimum conductor power cord (For a mobile

home installation, a UL approved 30A, 240V,

4-wire, #10 AWG minimum conductor power

cord is required.)

■ UL approved cord strain relief (may be supplied

with cord)

Gas Dryer

■ Channel-lock pliers (adjust leveling legs)

■ 1/2″ open-end wrench (lock leveling legs)

■ Carpenter’s level

■ Rigid or flexible metal 4″ (10.2 cm) duct

■ Duct tape

■ Vent hood

■ Flexible stainless steel or plastic-coated brass

connecting gas tube (if allowed by building code)

■ Connector for between dryer and flexible tube

(3/8″ pipe thread on dryer side, may be supplied

with flexible tube)

■ Pipe thread sealer

■ Open-end wrenches for flexible tube and

connector

Door Reversal

■ Plastic knife

■ Phillips head or #1 square screw driver

Customer ServiceCare and CleaningSafety Instructions

Installation Instructions

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

Comments to this Manuals

No comments

Ge DCD330G User Manual Page 7

Comments to this Manuals

Related products and manuals for Dryers Ge DCD330G