Ge GLDT690DWW User Manual download pdf (Page 6)

Installation Instruction

STEP 2 – ADJUST LEVELING LEGS

•Move the dishwasher close to the installation

location and lay it on its back.

•Measure installation height and dishwasher height.

Extend leveling legs out from the dishwasher base,

1/4”less than installation height.

Figure 8

Adjust to

Installation

Height

Adjust to

Installation

Height

STEP 3 – REMOVE TOEKICK

•Remove the 2 toekick screws. Lift off the 2 piece

toekick.

Figure

2-Screws

STEP 4 – INSTALL POWER CORD

Skip this step if dishwasher will be direct wired.

The power cord and connections must comply with

the National Electrical Code, Section 422and/or local

codes and ordinances.

Recommended power cord length is 54” min. and 64” max.

Connect incoming

power cord white (or ribbed)

to dishwasher white. Black

(or smooth) to black. Ground to dishwasher green

wire. Use UL listed wire nuts of appropriate size.

Replace junction box cover . Be sure wires are not

pinched under the cover .

White

Ground

Black

Check That White, Black and

Green Dishwasher Wires Are Threaded

Thru Hole in Back

Remove

Junction Box

Cover

Insert Power

Cord Wires Thru

Strain Relief

and Tighten

Use UL Listed

Wire Nuts

Figure 10

STEP 5 – INSTALL 90° ELBOW

Wrap 90 elbow with thread seal tape.

Install a 90 elbow onto the water valve.

•Do not over Tighten 90° elbow, water valve bracket

could bend or water valve fitting could break.

•Position the end of the elbow to face the rear of the

dishwasher .

Figure 11

Elbow

Fill

Hose

Thread

Seal Tape

Water

Valve

Bracket

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Comments to this Manuals

No comments

Ge GLDT690DWW User Manual Page 6

Comments to this Manuals

Related products and manuals for Dishwashers Ge GLDT690DWW