GE JGBP31 User Manual download pdf (Page 25)

The oven door must be closed and all controls set correctly for the cycle to work properly.

After a Clean Cycle (on some models)

You cannot set the oven for cooking until

the oven is cool enough for the door to be

unlatched.

You may notice some white ash in the oven.

Wipe it up with a damp cloth after the

oven cools.

If white spots remain, remove them with a soap-

filled scouring pad and rinse thoroughly with

a vinegar and water mixture.

These deposits are usually a salt residue

that cannot be removed by the clean cycle.

If the oven is not clean after one clean

cycle, repeat the cycle.

■ You cannot set the oven for cooking until

the oven is cool enough for the door

to unlock.

■ While the oven is self-cleaning, you can

touch the

Clock

pad to display the time

of day. To return to the clean countdown,

touch the

Cooking Time

pad.

■ If the shelves become hard to slide,

apply a small amount of vegetable oil or

cooking oil to a paper towel and wipe

the edges of the oven shelves with the

paper towel.

ge.com

How to Delay the Start of Cleaning (on some models)

You can set the oven control to delay-start the oven,

clean for a specific length of time and then turn off

automatically.

Make sure the clock shows the correct time

of day.

Follow the directions in the

Before a Clean

Cycle

section.

Latch the door.

NOTE:

Never force the latch. If the oven is

too hot, you will not be able to slide the

latch. Allow the oven to cool.

Touch the

Self Clean

pad.

Touch the

–

pads to set the

Clean Time.

The Clean Time is preset for 4 hours and 20 minutes.

You can change the Clean Time to any time between

3 and 5 hours, depending on the amount of soil in

your oven. If a different Clean Time is desired, touch

the + or – pads until the desired Clean Time is

displayed.

Touch the

Start Time

pad.

Change the Start Time by touching the + or – pads.

The start time will appear in the display.

Touch the

Start/On

pad.

The self-clean cycle will automatically begin

at the time set.

While the oven is self-cleaning, you can

touch the

Clock

pad to display the time

of day. To return to the clean countdown,

touch the

Self Clean

pad.

The oven shuts off automatically when the

clean cycle is complete, and 0:00 will flash

in the display.

Slide the latch handle to the left as far

as it will go and open the door.

To Stop a Clean Cycle (on some models)

Touch the

Clear/Off

pad.

Wait until the oven has cooled below the

locking temperature to unlatch the door.

You will not be able to open the door right

away unless the oven has cooled below the

locking temperature.

Operating

Instructions

Care and Cleaning

Installation

Instructions

Troubleshooting Tips

Safety Instructions

Consumer Support

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 55 56

Comments to this Manuals

No comments

GE JGBP31 User Manual Page 25

Comments to this Manuals

Related products and manuals for Cookers GE JGBP31