Ge MULTILINK ML1200 User Manual download pdf (Page 149)

CHAPTER 9: PORT MIRRORING AND SETUP PORT MIRRORING AND SETUP

MULTILINK ML1200 MANAGED FIELD SWITCH – INSTRUCTION MANUAL 9–3

9.3 Port Setup

9.3.1 Commands

Each port on the MultiLink ML1200 Managed Field Switch can be setup specific port

characteristics. The commands for setting the port characteristics are shown below.

The

device command enters the device configuration mode:

device

The

setport command configures the port characteristics:

setport port=<port#|list|range> [name=<name>] [speed=<10|100>] [duplex=<half|full>]

[auto=<enable|disable>] [flow=<enable|disable>] [bp=<enable|disable>]

[status=<enable|disable>] [lla=<enable|disable>]

The arguments for the

setport command are defined as follows:

•The

device argument sets up the MultiLink ML1200 Managed Field Switch in the

device configuration mode.

•The

name argument assigns a specific name to the port. This name is a designated

name for the port and can be a server name, user name or any other name.

•The

speed argument sets the speed to be 10 or 100 Mbps. This works only with 10/

100 ports; the value is ignored and no error shown for 10 Mbps ports.

•The

flow argument sets up flow control on the port.

•The

bp argument enables back pressure signaling for traffic congestion

management.

•The

status argument enabled/disables port operation

The show port command displays information about a specific port number.

show port[=<port number>]

1 2 ... 144 145 146 147 148 149 150 151 152 153 154 ... 343 344

No comments

Ge MULTILINK ML1200 User Manual Page 149