Ge 45606 User Manual download pdf (Page 14)

Please Note: After a power failure, the 45606 dimmer switch

returns to OFF state.

LED Indicator

The LED will be lit when the connected lighting is OFF.

This is the factory default setting and can be changed if your

primary controller supports the node conﬁguration function (see

Advanced Operation below)

ADVANCED OPERATION

The following Advanced Operation parameters require that you

have an advanced controller like the model 45601 Advanced

remote. Advanced remotes from other manufacturers may also

be able to change these settings; however, basic remotes do not

have this capability.

All On/All Off

Depending upon your primary controller, the 45606 dimmer switch

can be set to respond to ALL ON and ALL OFF commands in up to

four different ways. Some controllers may not be able to change

the response from its default setting. Please refer to your controller’s

instructions for information on whether or not it supports the

conﬁguration function and if so, how to change this setting.

The four possible responses are:

It will respond to ALL ON and the ALL OFF command

(default).

It will not respond to ALL ON or ALL OFF commands.

It will respond to the ALL OFF command but will not respond

to the ALL ON command.

It will respond to the ALL ON command but will not respond

to the ALL OFF command.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

No comments

Ge 45606 User Manual Page 14