GE JGP990 User Manual download pdf (Page 18)

IMPORTANT SAFETY

INSTRUCTIONS

The cooktop has been design-certified by CSA

International. As with any appliance using gas and

generating heat, there are certain safety precautions

you should follow. You’ll find these precautions in the

Important Safety Instuctions section in the front of this

Owner’s Manual. Read them carefully.

• Be sure your cooktop is installed properly by a qualified

installer or service technician.

• The cooktop must be electrically grounded in accordance

with local codes, or in their absence, with the National

Electrical Code ANSI/NFPA No. 70—Latest Edition.

• Installation of this cooktop must conform with local

codes, or in the absence of local codes, with the National

Fuel Gas Code ANSI Z223.1/NFPA 54—Latest Edition.

• Improper installation, adjustment, alteration, service

or maintenance can cause injury or property damage.

Refer to this manual. For assistance or additional

information, consult a qualified installer, service agency,

manufacturer (dealer) or the gas supplier.

• Disconnect electrical supply before servicing.

• Never reuse old flexible connectors. The use of old

flexible connectors can cause gas leaks and personal

injury. Always use NEW flexible connectors when

installing a gas appliance.

• Make sure the wall coverings around the cooktop can

withstand heat generated by the cooktop up to 200°F.

• Avoid placing cabinets above the cooktop.

• If cabinets are placed above the cooktop, allow a

minimum clearance of 30

″ between the cooking

surface and the bottom of protected cabinets.

• A non-combustible material must be installed on the

under side of the cabinet. Use a flame retardant

millboard at least 1/4″ (6.3 mm) thick, or gypsum board

at least 3/16″ (4.7 mm) thick, covered with 28 gauge

sheet steel or 0.020″ (.5 mm) thick copper. The

maximum depth of cabinets above the cooktop is 13″

(33 cm).

FOR YOUR SAFETY

If You Smell Gas:

1. Open windows.

2. Don’t touch any electrical switches.

3. Extinguish any open flame.

4. Immediately call your gas supplier.

Do not store or use gasoline or other flammable vapors

and liquids in the vicinity of this or any other appliance.

Installation Gas Downdraft Cooktop

Instructions

If you have questions, call 800.GE.CARES (800.432.2737) or visit our Website at: ge.com

BEFORE YOU BEGIN

Read these instructions completely and carefully.

•

IMPORTANT

–

Save these

instructions for local inspector’s use.

•

IMPORTANT

–

Observe all

governing codes and ordinances.

• Note to Installer – Be sure to leave these

instructions with the Consumer.

• Note to Consumer – Keep these instructions

for future reference.

• Proper installation is the responsibility of

the installer.

• Product failure due to improper installation is not

covered under the Warranty.

WARNING

–

Before beginning the

installation, switch power off at the service panel

and lock the service disconnecting means to prevent

power from being switched on accidentally. When

the service disconnecting means cannot be locked,

securely fasten a prominent warning device, such as

a tag, to the service panel.

In the Commonwealth of Massachusetts:

• This product must be installed by a licensed plumber

or gas fitter.

• When using ball-type gas shut-off valves, they shall be

the T-handle type.

• A flexible gas connector, when used, must not exceed

3 feet.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 79 80

Comments to this Manuals

No comments

GE JGP990 User Manual Page 18

Comments to this Manuals

Related products and manuals for Barbecues & grills GE JGP990