Ge GXRM10G User Manual download pdf (Page 6)

Installation Instructions

FEED WATER SUPPLY

Check and comply with local plumbing codes as you plan, then install a cold feed water supply fitting.

A. PREFERRED INSTALLATION

1. Close the cold water supply valve under

the sink.

2. Unscrew the flexible tubing from the

supply valve that connects to the COLD

water riser.

3. Install the feed water adapter* that is the

diameter to match either the 1/2″ or 3/8″

plumbing in your location. DO NOT

OVERTIGHTEN.

*Notice the direction of the feed water

adapter and coupling. It is installed

differently in order to match either the

1/2″ or 3/8″ plumbing in your location.

B. OPTIONAL HOME INSTALLATION

Where codes permit (Requires additional parts)

*For 1/2″ OD or larger metal tubing only.

NOTE: Codes in the state of Massachusetts

require installation by a licensed plumber and

do not permit the use of the saddle valve. For

installation, use plumbing code 248-CMR of the

Commonwealth of Massachusetts.

Saddle valve is available through GE Parts

and Services at 1.800.626.2002, part number

WS15X10023. Self piercing saddle valves are

not recommended.

1. Turn off the cold water supply and attach

saddle valve as shown in illustration

below.

DANGER: Many homes are

electrically grounded through the plumbing.

To protect yourself from serious injury or

fatal shock, use a battery-powered hand drill

only to make the hole. DO NOT USE AN

ELECTRIC DRILL.

2. Close the water supply valve by turning

the handle clockwise.

3. Open the main water supply valve and

several house faucets to purge air from

the system. Close faucets when water

runs smoothly.

Snug valve into bracket

(DO NOT OVERTIGHTEN)

Some threads

should be visible

Rubber gasket

Optional water supply connection (using saddle valve)*

Pre-drill

1/4″ hole

Seal—make sure

the seal is in place

Clamp X

Nut (2)—not

required if holes

in clamp are

threaded

Valve

Handle

Tubing adapter

Washer

Compression

nut



Clamp Z

Use to connect the tubing

*For 1/2 ″ OD or larger metal tubing only.

For 3/8″ Plumbing For 1/2″ Plumbing

Faucet

tubing line

Coupling

Adapter

Inlet valve

Cold water

supply valve

Faucet

tubing line

Cold water

supply valve

Coupling

Adapter

Gasket

Ferrule

Inlet valve

Nut

Gasket

1 2 3 4 5 6 7 8 9 10 11 ... 63 64

Comments to this Manuals

No comments

Ge GXRM10G User Manual Page 6

Comments to this Manuals

Related products and manuals for Water equipment Ge GXRM10G