GE EER3000 User Manual download pdf (Page 26)

Care and cleaning of the range.

Oven Floor

Do not clean the broil element. Any soil

will burn off when the element is heated.

Clean the oven floor with warm, soapy

water.

On some models, the bake element is not

exposed and is under the oven floor. If spillovers,

residue or ash accumulate on the oven floor,

wipe up before self-cleaning.

Broiler Pan & Grid

Do not clean the broiler pan or grid in a self-

cleaning oven.

After broiling, remove the broiler pan

from the oven. Remove the grid from the

pan. Carefully pour out the grease from

the pan into a proper container.

Wash and rinse the broiler pan and grid

in hot water with a soap-filled or plastic

scouring pad.

If food has burned on, sprinkle the grid

with detergent while hot and cover with

wet paper towels or a dishcloth. Soaking

the pan will remove burned-on foods.

Both the broiler pan and grid may be

cleaned with a commercial oven cleaner.

Both the broiler pan and grid can also be

cleaned in a dishwasher.

After broiling, remove the broiler

pan from the oven. Do not store a

soiled broiler pan and grid anywhere

in the range.

Storage Drawer Removal (on some models)

To remove the drawer:

Pull the drawer out until it stops.

Lift the front of the drawer until the

stops clear the guides.

Remove the drawer.

To replace the drawer:

Place the drawer rails on the guides.

Push the drawer back until it stops.

Lift the front of the drawer and push

back until the stops clear the guides.

Lower the front of the drawer and

push back until it closes.

Stop guide

Rail

Oven Light Replacement

CAUTION: Before replacing your oven

light bulb, disconnect the electrical

power to the range at the main fuse or

circuit breaker panel.

Be sure to let the light cover and bulb

cool completely.

To remove the cover:

Hold a hand under the cover so it

doesn’t fall when released. With

fingers of the same hand, firmly

push back the wire cover holder.

Lift off the cover.

Do not remove any screws to remove the cover.

Replace bulb with a 40-watt

appliance bulb.

To replace the cover:

Place it into groove of the light

receptacle. Pull wire forward to

the center of the cover until it

snaps into place.

Connect electrical power to

the range.

Wire cover holder.

Consumer Support Troubleshooting Tips Care and Cleaning Operating Instructions Safety Instructions

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 39 40

Comments to this Manuals

No comments

GE EER3000 User Manual Page 26

Comments to this Manuals

Related products and manuals for Warming drawers GE EER3000