GE V2FN Installation Guide download pdf

GEH-5895

Versaflood

II Signliter

INSTRUCTIONS

READ THOROUGHLY BEFORE INSTALLING

GENERAL

This luminaire is designed for use in outdoor

applications and should not be installed in areas of

limited ventilation or in high ambient temperature

enclosures. This fixture should be installed and main-

tained according to the following recommendations.

UNPACKING

This luminaire has been packed so that no parts

should have been damaged during transit. Inspect to

confirm.

3. If the luminaire is prewired with power supply cable,

proceed to instruction 3a or 3b, otherwise remove the

wiring shield to expose the terminal board (see Figure

4). Loosen the cable strain relief clamp and insert the

supply cable through the gland from the back 7 to 9

inches. Connect cable leads to the terminal board,

retract cable to a good wire dress and tighten the

strain relief clamp. Refer to the WIRING section of

this instruction. Replace the wiring shield and

reflector and install lamp. Close and latch the lens

door.

CAUTION

Unit will fall if not installed properly

• Follow installation instructions

WARNING

Risk of electric shock

• Turn power off before servicing

– see instructions

INSTALLATION

CAUTION: For aimed-up application, remove

two screws from rear bottom corners of back

housing, and re-install them in front housing

rear bottom corners.

Luminaires Installed Without Conduit

(Standard mounting)

Type SO (AWG 14-3) cable (normally supplied by

user) is recommended for electrical connections to this

luminaire.

1. Unlatch, open door and remove door assembly.

Remove reflector and shield.

2. Remove (4) knockouts in housing back. Using these

holes install housing to mounting surface with (4)

5/16 inch bolts, nuts and lock washers(*). Seal

around these bolts with appropriate sealing

compound(*).

*(Supplied by user.)

Figure 1 Figure 2

Figure 3 Figure 4

These instructions do not purport to cover all details or variations in equipment nor to provide for every possible contingency to be met in connection with installation, operation or

maintenance. Should further information be desired or should particular problems arise which are not covered sufficiently for the purchaser’s purposes, the matter should be referred

to GE Lighting Solutions.

Lighting Solutions

1 2 3 4

Summary of Contents

Page 1 - II Signliter

GEH-5895Versaflood ® II SignliterINSTRUCTIONSREAD THOROUGHLY BEFORE INSTALLINGGENERAL This luminaire is designed for use in outdoorapplications and sh

Page 2 - LAMP INSTALLATION/REPLACEMENT

3a. Pipe Mounted (See Figure 1) Mount the trunnion slipfitter on the support pipebracket and tighten all six set screws. Mount theluminaire and

Page 3 - Projecteur Versaflood

GEH-5895Projecteur Versaflood ® II SignliterINSTRUCTIONSLIRE ATTENTIVEMENT AVANT D'INSTALLERRisque d'électrocution• Mettre hors tension avan

Page 4 - ATTENTION

35-201578-7Y (8/02)ATTENTIONRisques de brûlure• Laissez refroidir la lampe et l’appareild’éclairage avant de les toucher.Risque de brûlure• Ne touchez