GE SEMT Installation Guide download pdf

GEH-3908F

INSTRUCTIONS

Town and Country,

Salem

™

Luminaires

READ THOROUGHLY BEFORE INSTALLING

GENERAL

This luminaire is designed for outdoor lighting service,

and should not be used in areas of limited ventilation, or in

high ambient temperature enclosures. Best results will be

obtained if installed and maintained according to the

following recommendations.

UNPACKING

This luminaire has been properly packed so that no parts

should have been damaged during transit. Inspect to

confirm.

MOUNTING

Loosen the captive screw or release the latch which holds

down the canopy, tilt canopy back toward the house side.

Connect power supply leads to the luminaire leads provided

or to the optional terminal board.

NOTE: Connect ground lead to the green ground

screw on the housing or terminal block.

LAMP INSTALLATION – HID

WARNING

Risk of electric shock

• Turn power off before servicing

– see instructions

CAUTION

Unit will fall if not installed properly

• Follow installation instructions

CAUTION

Risk of burn

• Allow lamp/fixture to cool before

handling

This luminaire is provided with means for mounting on

3.000'' max. outside diameter pole tops.

Feed the power supply leads through the slipfitter wire

access hole as the fixture is installed on the pole.

Orient canopy screw or latch toward street and level by

adjusting the three screws, and tighten.

(CAUTION: Tighten screws to 15 - 20 foot pounds

torque.)

WIRING

NOTE: Make all electrical connections in accordance

with the National Electrical Code and any applicable

local code requirements.

NOTE: Verify that supply voltage is correct by

comparing it to nameplate.

120/240 VOLT field RECONNECTABLE ballasts are

factory connected for 120 volt supply. For 240 volt opera-

tion, rewire per attached wiring tag.

NOTE: Use only lamps specified on nameplate.

Observe lamp manufacturer’s recommendations

and restrictions on lamp operation, particularly

ballast type, burning position, etc.

Damage may occur to the fixture if the lamp is inserted

while the power is on, or if the lamp is not tight in the

socket when the power is applied.

Lamp Tightness Mogul Base Lamp: The lamp should be

securely inserted to the NEMA-EEI specified torque of 35

inch-pounds, which is best achieved by very firmly tighten-

ing to insure application of sufficient torque. Tightening

must be sufficient to fully depress and load the center

contact of the socket.

Salem

Town and Country

TRCR

TR1C and TR1R

T10C and T10R

These instructions do not purport to cover all details or variations in equipment nor to provide for every possible contingency to be met in connection with installation, operation or

maintenance. Should further information be desired or should particular problems arise which are not covered sufficiently for the purchaser’s purposes, the matter should be referred

to GE Lighting Solutions.

Lighting Solutions

1 2

Summary of Contents

Page 1 - Luminaires

GEH-3908FINSTRUCTIONSTown and Country,Salem™ LuminairesREAD THOROUGHLY BEFORE INSTALLINGGENERALThis luminaire is designed for outdoor lighting service

Page 2 - 16943533----888

35-201578-E9 (8/01)LAMP INSTALLATION –INDUCTIVE TECHNOLOGY LAMPCAUTIONRisk of burn• Allow lamp/fixture to cool beforehandlingNOTE: Use only lamps spec

Comments to this Manuals

No comments

GE SEMT Installation Guide

Browse online or download Installation Guide for Unknown GE SEMT. GE SEMT Installation Guide User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Unknown GE SEMT