GE GS Series Installation Guide download pdf

Lighting

Installation Guide

imagination at work

(GS14 Series)

Lumination

LED Luminaires

BEFORE YOU BEGIN

Read these instructions completely and carefully.

WARNING/AVERTISSEMENT

RISK OF ELECTRIC SHOCK

• Turn power off before inspection, installation or removal.

• Properly ground electrical enclosure.

RISK OF FIRE

• Follow all NEC and local codes.

• Use only UL or IEC approved wire for input/output connections.

Minimum size 18 AWG (0.75mm

• Do not install insulation within 3 inches (76 mm) of luminaire top.

RISQUES DE DÉCHARGES ÉLECTRIQUES

• Coupez l’alimentation avant d’’inspecter, installer ou déplacer le luminaire.

• Assurez-vous de correctement mettre à la terre le boîtier d’alimentation électrique.

RISQUES D’INCENDIE

• Respectez tous les codes NEC et codes locaux.

• N’utilisez que des ls approuvés par UL ou IEC pour les entrées/sorties de

connexion. Taille minimum 18 AWG (0.75mm

• Maintenir une distance de 76 mm (3 pouces) entre le luminaire et l’isolant.

Save These Instructions

Use only in the manner intended by the manufacturer. If you have any questions, contact the manufacturer.

Prepare Electrical Wiring

Electrical Requirements

• The LED luminaire must be connected to the mains supply according to its ratings on the product label.

Grounding Instructions

• The grounding and bonding of the overall system shall be done in accordance to local electric code of the country

where the luminaire is installed.

1 2 3 4

Summary of Contents

Page 1 - LED Luminaires

GELightingInstallation Guideimagination at work(GS14 Series)LuminationTM LED LuminairesBEFORE YOU BEGINRead these instructions completely and carefull

Page 2 - Components Included

Mount the wrap-around brackets on the ceiling or support rail using appropriate hardware. After brackets are secured in place, install one side of the

Page 3 - Squeeze to release

Squeeze the two tray clips to release the geartray.4Lift geartray from housing.5Remove one or two of the end plug(s) as needed to wire the unit to the

Page 4 - Wiring Diagram

Wiring DiagramThis device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause